SECTION 4
TEST MODE
FLUORESCENT DISPLAY TUBE FULL ON AND� SERVO board (Conductor Side) �
KEY CHECK MODE
Procedure:
1. Connect TP(AFJ) and GND on the SERVO board with a lead
wire.
2. Press! button to turn the power ON.TP
IC101
3. The fluorescent display tube will fully turn on.(AFJ)
4. Pressing any button causes the set to enter the Key Check mode.IC204
In the Key Check mode, each time a button is pressed, nu-
meric value displayed on the tube is counted up. (However,
CN101
once the button is pressed, the value is not counted up even if
pressing the same button again.) Also, while a button is pressed,
its button number is displayed.
5. To exit from the Test mode, press! button to turn the power
OFF.
7-segment display
Count-up displayButton number display
Button Number Display
Button Name
(Display while a button is pressed)
PLAY MODEPartial onSIDE-ACUSTOM INDEX
FADE
C.SEC
DELETE
REPEATPartial onSIDE-B (TIME)(1)
MINC.FILE
INDEX
TIME000
EDIT/TIME FADE12
FILE13
ERASE00
CHECKPartial on135
79
111315
CLEARPartial on24
6810
1214N
FILTER20
mPartial on1B(JUST)
PROGRAM
INDEX PEAK
MPartial onSHUFFLEREPEATA-
AUTOSPACEEDIT
STEP _
A OPEN/CLOSEFull on
NPartial on and
nearby LED on
XPartial on and
nearby LED on
x888
PUSH ENTER23
11 |