The laser component in this productSAFETY CHECK-OUT
is capable of emitting radiation
exceeding the limit for Class 1.After correcting the original service problem, perform the following
safety check before releasing the set to the customer:
Check the antenna terminals, metal trim, Ometallized� knobs, screws,
The following caution label is located inside of the unit.and all other exposed metal parts for AC leakage. Check leakage as
described below.
LEAKAGE TEST
The AC leakage from any exposed metal part to earth ground and
from all exposed metal parts to any exposed metal part having a re-
turn to chassis, must not exceed 0.5 mA (500 microampers).
Leakage current can be measured by any one of three methods.
This appliance is classified1. A commercial leakage tester, such as the Simpson 229 or RCA
as a CLASS 1 LASER
WT-540A. Follow the manufacturersO instructions to use these
product.instruments.
The CLASS 1 LASER
PRODUCT MARKING is
2. A battery-operated AC milliammeter. The Data Precision 245 digi-
located on the rear exterior.
tal multimeter is suitable for this job.
3. Measuring the voltage drop across a resistor by means of a VOM
CAUTIONor battery-operated AC voltmeter. The Olimit� indication is 0.75
Use of controls or adjustments or performance of proce-V, so analog meters must have an accurate low-voltage scale. The
dures other than those specified herein may result in haz-Simpson 250 and Sanwa SH-63Trd are examples of a passive VOM
ardous radiation exposure.that is suitable. Nearly all battery operated digital multimeters that
have a 2V AC range are suitable. (See Fig. A)
Notes on Chip Component Replacement
? Never reuse a disconnected chip component.To Exposed Metal
? Notice that the minus side of a tantalum capacitor may be dam-Parts on Set
aged by heat.
MODEL IDENTIFICATION
AC
0.15?F1.5kWvoltmeter
� Back Panel �(0.75V)
Earth Ground
Fig. A. Using an AC voltmeter to check AC leakage.
CDP-XE400
US Model: 4-977-587-51
CDP-XE500
US Model: 4-977-587-11
E Model: 4-977-587-31
Australian Model: 4-977-587-41
Chinese Model: 4-977-587-91
AEP, German, East European Model: 4-978-388-01
UK Model: 4-978-388-11
� 2 � |