Precautions
1. Recording Copyright
5. Care
Recording of copyrighted material for other thanFrom time to time you should wipe the front and
personal use is illegal without permission of the
rear panels and the cabinet with a soft cloth. For
copyright holder.heavier dirt, dampen a soft cloth in a weak solu-
2. Powertion of mild detergent and water, wring it out dry,
WARNINGand wipe off the dirt. Following this, dry immedi-
BEFORE PLUGGING IN THE UNIT FOR THE FIRSTately with a clean cloth.
TIME, READ THE FOLLOWING SECTION CARE-Do not use rough material, thinners, alcohol or
FULLY.other chemical solvents or cloths since these could
damage the finish or remove the panel lettering.
The voltage of the available power supply differs
according to country or region. Be sure that the6. Points to remember
If this unit is brought from a cold environment to
power supply voltage of the area where this unit
will be used meets the required voltage (e.g., ACa warm one or is in a cold room that is quickly
heated, condensation may form on the pickup,
230 V, 50 Hz or AC 120 V, 60 Hz) written on the
rear panel.preventing proper operation. In this case, remove
Turning off the standby button does not shut offthe disc and leave the power ON for about one
hour to remove the condensation.
the power completely. So the power cord should
be removed from the AC outlet when the unit isWhen transporting this unit, be careful not to
bump it.
not used for a prolonged time.
3. Do not touch this unit with wet hands
DANGER:
Do not handle this unit or power cord when yourINVISIBLE LASER RADIATION WHEN OPEN AND
hands are wet or damp. If water or any other liq-
uid enters the case, take this unit to an authorizedINTERLOCK FAILED OR DEFEATED. AVOID DIRECT
EXPOSURE TO BEAM.
service center for inspection.
4. Location of this unitCAUTION:
THIS PRODUCT UTILIZES A LASER. USE OF CON-
Place this unit in a well-ventilated location.TROLS OR ADJUSTMENTS OR PERFORMANCE OF
Take special care to provide plenty of ventilation
PROCEDURES OTHER THAN THOSE SPECIFIED
on all sides of this unit especially when it is placedHEREIN MAY RESULT IN HAZARDOUS RADIATION
in an audio rack. If ventilation is blocked, this unit
may overheat and malfunction.EXPOSURE.
Do not expose this unit to direct sunlight or heat-
ing units as this unitOs internal temperature may
rise and shorten the life of the pickup.
Avoid damp and dusty places and places directly
affected by vibrations from the speakers. In par-
ticular, avoid placing the unit on or above one of
the speakers.
Be sure this unit is placed in a horizontal position.
Never place it on its side or on a slanted surface as
it may malfunction.
Do not place near tuners or TV sets.
If placed next to a TV or tuner, it may cause recep-
tion interference resulting in some noise in the TV
or tuner output.
4 |
ACEC
ONKYO
