Precautions
1. Warranty ClaimIf placed next to a TV or tuner, it may cause recep-
You can find the serial number on the rear paneltion interference resulting in some noise in the TV
of this unit. In case of warranty claim, please re-or tuner output.
port this number.
6. Care
2. Recording CopyrightFrom time to time you should wipe the front and
Recording of copyrighted material for other thanrear panels and the cabinet with a soft cloth. For
personal use is illegal without permission of theheavier dirt, dampen a soft cloth in a weak solu-
copyright holder.
tion of mild detergent and water, wring it out dry,
3. Powerand wipe off the dirt. Following this, dry immedi-
WARNINGately with a clean cloth.
BEFORE PLUGGING IN THE UNIT FOR THE FIRSTDo not use rough material, thinners, alcohol or
TIME, READ THE FOLLOWING SECTION CARE-other chemical solvents or cloths since these could
FULLY.damage the finish or remove the panel lettering.
The voltage of the available power supply differs7. Points to remember
according to country or region. Be sure that theIf this unit is brought from a cold environment to
a warm one or is in a cold room that is quickly
power supply voltage of the area where this unitheated, condensation may form on the pickup,
will be used meets the required voltage (e.g., AC
230 V, 50 Hz or AC 120 V, 60 Hz) written on thepreventing proper operation. In this case, remove
rear panel.the disc and leave the power ON for about one
Turning off the standby button does not shut offhour to remove the condensation.
the power completely. So the power cord shouldWhen transporting this unit, be careful not to
bump it.
be removed from the AC outlet when the unit is
not used for a prolonged time.
4. Do not touch this unit with wet handsDANGER:
Do not handle this unit or power cord when yourINVISIBLE LASER RADIATION WHEN OPEN AND
INTERLOCK FAILED OR DEFEATED. AVOID DIRECT
hands are wet or damp. If water or any other liq-EXPOSURE TO BEAM.
uid enters the case, take this unit to an authorizedCAUTION:
service center for inspection.
5. Location of this unitTHIS PRODUCT UTILIZES A LASER. USE OF CON-
Place this unit in a well-ventilated location.TROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED
Take special care to provide plenty of ventilationHEREIN MAY RESULT IN HAZARDOUS RADIATION
on all sides of this unit especially when it is placedEXPOSURE.
in an audio rack. If ventilation is blocked, this unit
may overheat and malfunction.
Do not expose this unit to direct sunlight or heat-
ing units as this unitOs internal temperature may
rise and shorten the life of the pickup.
Avoid damp and dusty places and places directly
affected by vibrations from the speakers. In par-
ticular, avoid placing the unit on or above one of
the speakers.
Be sure this unit is placed in a horizontal position.
Never place it on its side or on a slanted surface as
it may malfunction.
Do not place near tuners or TV sets.
4 |
ACEC
ONKYO
