Hooking Up the TV/DVD 7
1
Disconnect all equipment from the power sources before changing any
connections. If you are connecting other equipment, such as a VCR or a stereo, to the
TV/DVD, read the ownerOs manuals of the other equipment as well. You may need to refer to
pages 9-10 of this manual, too.
2
Hook up your TV/DVD using one of the connections shown (2A-2D).
2A.
Hooking Up Your TV/DVD with aConnect a Cable signal
Cable Signal or Outdoor Antennaor an antenna to the
Connect a Cable signal or an antenna to theANT(enna) Jack.
ANT(enna) Jack.
Note to Cable TV (CATV)
System Installer:
This reminder is provided to call the CATV
system installerOs attention to Article 820-40ANT.
of the NEC that provides guidelines for prop-
er grounding and, in particular, specifies that
the cable ground shall be connected to the
grounding system of the building as close to
the point of cable entry as practical.
OUT
2B.IN
Hooking Up Your TV/DVD
with a Cable Box
Connect the Cable signal
Connect the Cable signal to the IN Jack on
to the IN Jack on the
the Cable Box.
Cable Box.
Connect an RF coaxial cable to the OUT Jack
on the Cable Box and to the ANT(enna) Jack
Connect an RF coaxial
on the TV/DVD.
cable (75-ohm, not sup-
To view any channel, set the TV/DVD to the
plied) to the OUT Jack
Cable Box output channel (channel 03 or 04)
on the Cable Box and to
while in TV mode. Then, select channels at
the ANT(enna) Jack on
the Cable Box.
the TV/DVD.
ANT.
Instructions continue on page eight. |
ACEC
PHILIPS
