Do not expose the discs to direct sunlight or
heat sources such as hot air-ducts, or leaveMaintenance
them in a car parked in direct sunlight where
there can be a considerable rise in temperature
Fuse replacement
inside the car.
When replacing the fuse, be sure to use one
matching the amperage rating started on the
original fuse. If the fuse blows, check the
power connection and replace the fuse. If the
fuse blows again after replacement, there may
be an internal malfunction. In such a case,
consult your nearest Sony dealer.
Before playing, clean the discs with an optional
cleaning cloth. Wipe each disc from the center
out.
Do not use solvents such as benzine, thinner,Fuse (10 A)
commercially available cleaners, or antistatic
spray intended for analog discs.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as
this could damage the unit.
Cleaning the connectors
Note on moisture condensationThe unit may not function properly if the
On a rainy day or in a very damp area,connectors between the unit and the front
moisture may condense on the lenses insidepanel are not clean. In order to prevent this,
the CD player. Should this occur, the unit willopen the front panel by pressing (RELEASE),
not operate properly. In this case, remove thethen detach it and clean the connectors with a
disc and wait for about an hour until thecotton swab dipped in alcohol. Do not apply
moisture evaporates.too much force. Otherwise, the connectors may
be damaged.
When you play 8 cm (3 in.) CDs
Use the optional Sony compact disc single
adapter (CSA-8) to protect the CD player from
damage.
Main unit
Back of the front panel
Notes
? For safety, turn off the engine before cleaning
the connectors and remove the key from the
ignition switch.
? Never touch the connectors directly with your
fingers or any metal device.
23 |
ACEC
SONY
