MaintenanceDismounting the unit
Fuse replacement1Press the clip inside the front cover with
When replacing the fuse, be sure to use onea thin screwdriver, and gently pry the
matching the amperage rating stated on thefront cover free.
original fuse. If the fuse blows, check the
power connection and replace the fuse. If the
fuse blows again after replacement, there may
be an internal malfunction. In such a case,
consult your nearest Sony dealer.
2Repeat step 1 on the left side.
The front cover is removed.
Fuse (10 A)
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as
this could damage the unit.3Use a thin screwdriver to push in the clip
on the left side of the unit, then pull out
Cleaning the connectorsthe left side of the unit until the catch
The unit may not function properly if theclears the mounting.
connectors between the unit and the front
panel are not clean. In order to prevent this,
open the front panel by pressing (OPEN), then
detach it and clean the connectors with a
cotton swab dipped in alcohol. Do not apply
too much force. Otherwise, the connectors may
be damaged.
4Repeat step 3 on the right side.
Main unit
5Slide the unit out of the mounting.
Back of the front panel
Notes
YFor safety, turn off the engine before cleaning
the connectors and remove the key from the
ignition switch.
YNever touch the connectors directly with your
fingers or any metal device.
28 |
ACEC
SONY
