CD/MD playback
TroubleshootingA disc cannot be loaded.
Another CD/MD is already loaded.
The following checklist will help you re Tmehed yC D/MD is forcibly inserted upside down
problems you may encounter with your unoirt in. the wrong way.
Before going through the checklist below, check
Playback does not begin.
the connection and operating procedures. Defective MD or dirty CD.
CD-R/CD-RW that is not finalized.
General You tried to playback a CD-R/CD-RW not
No sound.designed for audio use.
Rotate the volume control dial clockwSiomse te CDo -Rs/CD-RWs may not play due to
adjust the volume.its recording equipment or the disc
Cancel the ATT function.condition.
Set the fader control to the centeA dr piosc isitios aun ftoomatir cally ejected.
a 2-speaker system.The ambient temperature exceeds 50°C.
The contents of the memory have been The operation buttons do not function.
erased.CD will not be ejected.
The RESET button has been pressed.Press the RESET button.
tStore again into the memory.
The power cord or battery has been The sound skips from vibration.
The unit is installed at an angle of more than
disconnected.
60°.
The power connecting cord is not connected The unit is not installed in a sturdy part of
properly.
the car.
No beep sound.
The sound skips.
The beep sound is canceled (page 18).
An optional power amplifier is connected Dirty or defective disc.
and you are not using the built-in amplifier.
Indications disappear from/do not appearRad ini o reception
the display.
Preset tuning is not possible.
The clock display disappears if you press
Store the correct frequency in the memory.
(OFF) for 2 seconds. The broadcast signal is too weak.
tPres(s OFF) again for 2 seconds to
The stations cannot be received.
display the clock.
Remove the front panel and clean the The sound is hampered by noises.
Connect a power antenna control lead (blue)
connectors. See ?Cleaning the connectors?
on page 22 for details.or accessory power supply lead (red) to the
power supply lead of the car?s antenna
Stored stations and correct time are erased.booster. (Only when your car has built-in
The fuse has blown.
FM/AM antenna in the rear/side glass.)
Makes noise when the ignition key is in the Check the connection of the car antenna.
ON, ACC, or OFF position.
The auto antenna will not go up.
The leads are not matched correctly with the tCheck the connection of the power
car?s accessory power connector.antenna control lead.
No power is being supplied to the unit. Check the frequency.
Check the connection. If everything iWshe in n the DSO mode is on, the sound is
order, check the fuse.sometimes hampered by noises.
The car does not have an ACC positiotn.Set the DSO mode to ?OFF? (page 19).
tPres(Ss OURCE) (or insert a disc) to turn Automatic tuning is not possible.
on the unit.
The local seek mode is set to ?ON.?
The power is continuously supplied to the tSet the local seek mode to ?OFF? (page
unit.18).
The car does not have an ACC position.The broadcast signal is too weak.
tPerform manual tuning.
The power antenna does not extend.
The power antenna does not have a relay box.
Cannot turn off the ?--------? indication.continue to next patge
You entered the name edit mode.
tPress (LIST) for 2 seconds.
25 |
ACEC
SONY
