SECTION 5
MECHANICAL ADJUSTMENT
Y Elevator Height (Address) Adjustment
Note:This adjustments is necessary when the system controller (IC201),Adjustment Method:
variable resistor (RV201), slider (R), slider (L),1. or cLoad a disc maghassis (ELV)azine, and place the set vertically as shown
was replaced for any repair.below.
Connection:2. Connect the regulated power supply, and turn the power on.
power supply
3. Press the DISC button on the wired remote commander (RM-
X87/X88) and select DISC 5.
+
GND4. At this time, if the elevator shaft does not position between
comb teeth A and B at addresses 5 and 6 as shown below,
adjust the following.
5. Press repeatedly the DISC + and � buttons on the wired re-
mote commander (RM-X87/X88) so that the elevator shafts
moves from address 6 to address 5, or from 5 to 6. At this
time, adjust RV201 on the main board so that the elevator shaft
positions smoothly between comb teeth A and B.
wired remote commander6. Further, place the set horizontally and make same adjustment
(RM-X87: CDX-530RF/535R)as mentioned above.
(RM-X88: CDX-434R)
7. After adjustment at addresses 5 to 6 is finished, check all op-
erations from addresses 1 to 10 with the set placed vertically
and horizontally respectively to confirm that the elevator shaft
CDX-434RF/530RF/535RFpositions in a range between comb teeth A to B.
comb tooth at address 6comb tooth at address 6
elevator shaft
AA
elevator shaft
BB
comb tooth at address 5
comb tooth at address 5
OKNG
RV201
21 |
ACEC
SONY
