CDX-CA850/CA850X/CA860X
DimensionsApprox. 178 � 50 � 177 mm
(7 1/8 � 2 � 7 in.) (w/h/d)
Mounting dimensionsApprox. 182 � 53 � 162 mm
(7 1/4 � 2 1/8 � 6 1/2 in.) (w/h/d)
MassApprox. 1.3 kg
(2 lb. 10 oz.)
Supplied accessoriesParts for installation and connections (1 set)
Front panel case (1)
Rotary commander
RM-X5S
Card remote commander
RM-X112 (CDX-CA850X/CA860X)
RM-X113 (CDX-CA850)
Note
This unit cannot be connected to a digital preamplifier or an equalizer.
Design and specifications are subject to change without
notice.
SERVICE NOTES
Y US, Canadian modelY AEP, UK model
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
If the optical pick-up block is defective, please replace the whole
optical pick-up block.
This label is located on the bottom of the chassis.
Never turn the semi-fixed resistor located at the side of optical
pick-up block.
optical pick-up bk loc
This label is located on the drive unit's internal
chassis.
When replacing the chassis (T.U) of mechanism deck which have
the OCAUTION LABEL� attached, please be sure to put a new
CAUTION LABEL (3-223-913-11) to the chassis (T.U).
semi-fixed resistor
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCKNOTES ON LASER DIODE EMISSION CHECK
OR BASE UNITThe laser beam on this model is concentrated so as to be focused on
The laser diode in the optical pick-up block may sufthe disc reflective surface by the objective lens in the optical pick-fer electrostatic
breakdown because of the potential difference generated by theup block. Therefore, when checking the laser diode emission, ob-
charged electrostatic load, etc. on clothing and the human bodyserve from more than 30 cm away from the objective lens..
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repairNotes on Chip Component Replacement
parts." Never reuse a disconnected chip component.
The flexible board is easily damaged and should be handled with" Notice that the minus side of a tantalum capacitor may be dam-
care.aged by heat.
SAFETY-RELATED COMPONENT WARNING!!ATTENTION AU COMPOSANT AYANT RAPPORT
� LA S?CURIT?!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND INLES COMPOSANTS IDENTIFI?S PAR UNE MARQUE 0 SUR LES
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.DIAGRAMMES SCH?MATIQUES ET LA LISTE DES PIéCES
SONT CRITIQUES POUR LA S?CURIT? DE FONCTIONNEMENT.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSENE REMPLACER CES COMPOSANTS QUE PAR DES PIéCES
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.SONY DONT LES NUM?ROS SONT DONN?S DANS CE MANUEL
OU DANS LES SUPPL?MENTS PUBLI?S PAR SONY.
2 |
ACEC
SONY
