CDX-R30M/R3310/R3410/R3410S
Ver. 1.1
Tone controlsLow: ?10 dB at 60 Hz (XPLOD)
Mid: ?10 dB at 1 kHz (XPLOD)CAUTION
High: ?10 dB at 10 kHz (XPLOD)Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardousPower requirements12 V DC car battery
(negative ground)
radiation exposure.DimensionsApprox. 178 � 50 � 179 mm
(7 1/8 � 2 � 7 1/8 in.) (w/h/d)
Mounting dimensionsApprox. 182 � 53 � 161 mm
If the optical pick-up block is defective, please replace the whole
(7 1/4 � 2 1/8 � 6 3/8 in.) (w/h/d)
MassApprox. 1.2 kg (2 lb 10 oz)optical pick-up block.
Supplied accessoriesParts for installation and connections (1 set)Never turn the semi-fixed resistor located at the side of optical
Front panel case (1)
pick-up block.Card remote commander RM-X151
US and foreign patents licensed from Dolby Laboratories.
optical pick-up
Note
This unit cannot be connected to a digital preamplifier or an equalizer which is Sony
BUS system compatible.
Design and specifications are subject to change without
notice.
SERVICE NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.semi-fixed resistor
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused onY AEP, UK, E model only.
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission, ob-
serve from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
YNever reuse a disconnected chip component.
Y Notice that the minus side of a tantalum capacitor may be
damaged by heat.This label is located on the bottom of the chassis.
TEST DISCS
This set can playback CD-R and CD-ROM discs. The following
test discs should be used to check the capability:
CD-R test disc TCD-R082LMT (Part No. J-2502-063-1)
CD-RW test disc TCD-W082L (Part No. J-2502-063-2)
SAFETY-RELATED COMPONENT WARNING!!ATTENTION AU COMPOSANT AYANT RAPPORT
� LA S?CURIT?!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND INLES COMPOSANTS IDENTIFI?S PAR UNE MARQUE 0 SUR LES
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.DIAGRAMMES SCH?MATIQUES ET LA LISTE DES PIéCES
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSESONT CRITIQUES POUR LA S?CURIT? DE FONCTIONNEMENT.
NE REMPLACER CES COMPOSANTS QUE PAR DES PIéCES
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.SONY DONT LES NUM?ROS SONT DONN?S DANS CE MANUEL
OU DANS LES SUPPL?MENTS PUBLI?S PAR SONY.
2 |
ACEC
SONY
