Troubleshooting
The power doesnOt come on.Sound is distorted.
M Is the guitar connected correctly to the M Are the EFFECT TONE (LOW/HIGH),
INPUT R (MONO) jack?BRILLIANCE, and AMBIENCE knobs
? Check the connections again (p. 3�9).positioned correctly?
* When running off batteries, the unit wonOt? Sounds may become distorted with the
switch on unless thereOs something pluggedknobs at certain settings. Turn down one or
more of these knobs, or turn down the
into the INPUT jack. This helps conserve the
batteries.E.LEVEL knob until the PEAK indicator
does not light up too frequently. If in spite
M Is the plug connected to the INPUT L jack?of these measures the sound is still
? When using battery power, connect the distorted, lower the output level of the
plug to the INPUT R (MONO) jack.device connected to the INPUT jacks, or set
M Have the batteries run down?the LEVEL switch to AMPLIFIER SEND/
? Replace with fresh batteries (p. 2).RETURN (+4 dBu).
M Is the specified AC adaptor (PSA-series MIs the LEVEL switch set to GUITAR/BASS?
sold separately) connected correctly??When connecting to guitar amps, bass amps,
? Check the connections again (p. 3�9).or other such gear, or when connecting to
equipment that outputs sound at high
volumes, set the LEVEL switch to
There is no sound/volume
AMPLIFIER SEND/RETURN (+4 dBu).
is too low.
MIs the other equipment connected correctly?Pressing the MEMORY/MANUAL
? Check the connections again (p. 3�9).
pedal does not call up the
M Is the volume turned down on the
intended memory.
connected guitar/bass amp, effects
processor, or other device?M Is the proper Pedal mode set for your
current application?
? Check the settings on the connected
equipment (p. 3�9).? The MANUAL/MEMORY pedal (or the
MANUAL/MEMORY pedal when pressed
M Is the LEVEL switch on the rear panel set
simultaneously with EFFECT ON/OFF
correctly?pedal) functions differently according to the
? Set the LEVEL switch to match the Pedal mode settings. Use the most
connected equipment (p. 3�9).appropriate setting for your particular
M Is the direct sound ON/OFF set to OFF?application (p. 11�12).
? Only the effect sound is output when this is
set to OFF. When you want to output the The volume level of the
direct sound as well, set this to ON (p. 22).instrument connected to INPUT
M Is the effect level set to minimum?jack is too low.
? Operate the E.LEVEL knob to adjust the
M Could you be using a connection cable
effect level.that contains a resistor?
? Use a connection cable that does not
contain a resistor.
25 |
ACEC
BOSS
