For U.S.A.
Federal Communications CommissionRules. Operation is subject to the following
Radio Frequency Interference Statementtwo conditions:
Note: This equipment has been tested and found(1) This device may not cause harmful
to comply with the limits for a Class B digitalinterference, and
device, pursuant to Part 15 of the FCC Rules. These(2) This device must accept any interference
limits are designed to provide reasonable protectionreceived, including interference that may
cause undesired operation.
against harmful interference in a residential
installation. This equipment generates, uses andResponsible Party:
can radiate radio frequency energy and, if notPanasonic Corporation of North America
installed and used in accordance with theOne Panasonic Way
instructions, may cause harmful interference toSecaucus, NJ 07094
radio communications. However, there is noTel No: 1-800-LAPTOP5
guarantee that interference will not occur in a(1-800-527-8675)
particular installation. If this equipment does causeFCC RF Exposure Warning:
harmful interference to radio or television reception,
which can be determined by turning the equipmentThis equipment complies with FCC radiation
off and on, the user is encouraged to try to correctexposure limits set forth for an uncontrolled
environment.
the interference by one or more of the followingThis equipment must be installed and oper-
measures:ated in accordance with provided instructions.
Reorient or relocate the receiving antenna.This transmitter must not be co-located or
Increase the separation between the equip-operated in conjunction with any other an-
ment and receiver.tenna or transmitter.
Connect the equipment into an outlet on a
circuit different from that to which the re-Notice for the products using LCD
ceiver is connected.This product uses one or more fluorescent
Consult the Panasonic Service Center or anlamps containing a small amount of mercury.
experienced radio/TV technician for help.It also contains lead in some components.
WarningDisposal of these materials may be regulated
To assure continued compliance, use onlyin your community due to environmental con-
shielded interface cables when connecting to asiderations. For disposal or recycling infor-
computer or peripheral. Also, any changes ormation please contact your local authorities,
or the Electronics Industries Alliance:
modifications not expressly approved by the<http://www.eiae.org.>
party responsible for compliance could void the
user?s authority to operate this equipment.
This device complies with Part 15 of the FCC
For Canada
Industry Canada
This product complies with RSS210 of Industry Canada.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
5operation of the device. |
ACEC
PANASONIC
