TH-V70
Removing the DVD mechanism D
DVD mechanism
assembly (See Figs. 5 and 6.)assembly
Remove the top plate.
D
Remove the bottom panel.
Remove the top panel.
LED board
1.From the top side of the main body, disengage the CN812
claw c of the DVD mechanism assembly and then
remove the push button.
2.Remove the five screws D and screw E attaching
the DVD mechanism assembly.
Claw c
3.Disconnect the wire from connector CN812 on the DPush buttonE
LED board.
Fig.5
DVD servo board
4.Disconnect the connectors CN502 and CN503 on
the DVD servo board from connectors CN801 and
CN803 on the main board while lifting the DVD
CN503
mechanism assembly in an upward direction.
CN502
Front panel assembly
Removing the front panel assembly
(See Figs. 7 and 8.)
Remove the top plate.
CN803CN801
Remove the bottom panel.Main board
Remove the top panel.Fig.6
Remove the DVD mechanism assembly.
1.Remove the wire clamp bundling the wires of the Wire clamp
front panel assembly.Main boardBottom chassis
2.Remove the card wire of the front panel assembly
from the wire holder.Wire holder
CN814
3.Disconnect the wires from connectors CN106 and Wire
Bottom
CN814 on the main board.
chassis hole
CN813
CN802IC953
4.Disconnect the card wires from connectors CN802
and CN813 on the main board.CN106
5.From the front side of the main body, remove the
Card wires
two screws F attaching the front panel assembly.Claws dClaws d
6.Disengage the claws d of the front panel assembly Fig.7
from the bottom chassis and then remove the front
panel assembly in the direction of arrow. Front panel assembly
[Reference]
Before attaching the front panel assembly,
pass the card wire of the front panel assembly
through the hole on the bottom chassis.
After attaching the front panel assembly,
bundle the wires and card wire of the front
Bottom chassis
panel assembly using a wire clamp. F
Fig.8
[Caution]
In the assembly, arrange the wires and wire
clamp so that they are not touch to the
regulator IC(IC953).
1-7 |
ACEC
JVC
