Mounting the Front Slider and Rear Slider
1. Position the unit with the rear side facing down, then rotate
the third gear in the direction of the arrow (clockwise) until the
lift arm comes to the position at which the holes are exposed,
as shown in Fig. 45-1.
2. Mount the front slider from the top.
Rotate the third gear counterclockwise until the hole of the
slider is lined up with the right hole of the stud, as shown in
Fig. 45-2.
3. Mount the E-washer on the shaft.
4. Position the unit with the front side facing down, then mount
Stud
the rear slider. Check that the (r), (s) and (t) positions are
correctly mounted as shown in Fig. 46.Front SliderE-WasherPosition so that the
5. Rotate the third gear in the direction of the arrow stud and right hole
(counterclockwise) until the lifter unit is at the top position.are lined up
Check after mounting
Fig. 45-2
Fig. 45
Rotate the third gear to
move the slider
Set so the holes
Fig. 45-1are exposed
Rotate until the
holes are lined up
rst
Rotate the third
gear to move the
slider
Fig. 46
ç�ô�ü |
ACEC
JVC
