cl 59323 printers spreads 11/12/02 11:47 AM Page 1
INSTALLATIONOPERATION
TUMBLE DRYER VENTINGWhen using a vent hose, remember the following points:Open the door.NEVER SWITCH THE DRYER OFF AND LEAVE A
� The vent hose must be at least 10cm (4 ins) in diameter.HOT LOAD IN THE DRUM.Your tumble dryer will release warm, damp air in one of these
three ways:Load clothes loosely into the drum.
�No more than three right-angled bends should be allowed
When drying large items such as sheets, we suggest you
when positioning the vent hose.
Load sheets first, starting with one corner.periodically stop the dryer to redistribute the load.
� The vent hose must not be shared with other appliances, for
example, a cooker hood outlet.Close the door.To stop the machine during the middle of the programme simply
� When drying, the vent hose must always be extended to anopen the door; the drum will stop rotating automatically and
open door or window.Dry your hands.restart when you close the door.
FINAL INSTALLATIONCheck that the timer is in the �0O position.To lengthen or shorten a timed programme, reset the timer knob.
Place the filter in its operating
(1) Front Venting. Venting(2) Fixed Rear Venting. Venting
Plug in the machine.
through a hole at the bottom ofposition as shown in the diagram.through a grille on the plinth.
A kit is available to conthe bacvert tok panel. A vent hose isIf you wish to change the side onAFTER REMOVING THE DRIED CLOTHES:
Select correct heat position (see programme chart on control
rear venting.available to convert towhich your door opens, see the
panel for recommendations).
extendible rear venting.ALWAYS CLEAN THE FILTER.Failure to clean the filter willinstructions on the back page.
extend drying times and could cause the safety cut-out to
Remove any dust by wiping the drumSet the timer to the required time setting (see programme chart
operate. There are two types of filter your dryer main contain.
and door with a damp cloth. Any initialon control panel for recommendations).
smell from the heater should
(3) Extendible Rear Venting.
disappear after the first period ofThe drum will begin rotating. Reversing drum models will stop�Pull the filter upwards and away
This contains a retractable vent
heating.every few minutes to rotate in the reverse direction for a shortfrom the appliance.
hose.
Position the tumble dryer so that thetime.
�Remove any threads or fluff by
plug remains accessible after
installation.Should the clothes become dry before the cycle has finished, or ifhand or with a soft brush.
an excessive programme time has been selected, the drum will
FITTING OF FILTER
The best solution is to make a permanent connection throughcontinue to rotate while the thermostat will automatically switch�Slide the filter back
either a wall or a window. This is particularly recommended fGrip middle piece of filter with fingersor.
the heater off to prevent over-drying and save energy.
small, cool rooms and a kit for this purpose is availabFace the brle as anush bar at the bottom�W ash the filter occasionally in
accessory. However, venting arrangement (1) requires that it beedge of the filter to the front.There is an automatic 12 minute cool down period at the end ofdetergent solution and with a
converted to rear venting before a permanent connection can beSlide the filter into the space belowevery cycle, during which the heater is switched off. This helps tosoft brush to remove small
made.the door in a right angle position.minimise creasing.particles.
THE CONTROLSPREPARATIONADDITIONAL INFORMATION
A. THE TIMERCheck care labels inside the garments.ANY PROBLEMSOPTIONAL EXTRAS
Select the requiredCARE LABELS YOU MAY FIND ON YOUR
If the clothes are not dryafter normal drying time:
Front to Extendible Rear Venting Kitdrying time based
FABRICS
on the� Check that you used the correct heater setting.To convert your dryer from front venting to extendible rear venting.
recommendations
Suitable for tumble drying� Check that you have not set the timer within a coolVent Hose
on the controlB
down period.Only available for fixed rear dryers. Leads the warm, damp air to
panel.
ATumble dry using full heatan open door or window.
� Check that the lint filter has been cleaned. A blocked
W all/Window Vent Kit
Tumble dry using half heatfilter will restrict the airflow.
To make a permanent connection through a wall or window. Front
� Check that your dryer is heating - below the door to the
B. HEAT SWITCH(ES)venting dryers need converting to rear venting before installing thisDo not tumble dry
right side, should feel warm to the touch after the first
kit (see �Front to Extendible Rear Venting KitO above).
Select the required10-15 minutes of its programme. Failure to heat may
Stacking Kit
heat setting basedindicate the safety cut-out has operated. To reset,
Do not tumble dry woollen or wool mixture articles unless the
on thesimply press the red button at the rear of the machineTo enable y.our dryer to be secured onto the top of a front loading
article is labelled to be suitable due to a possibility of shrinkage.
recommendationsIf it has operated, a sharp Oclick� will be heard.washing machine (to saThis cut-ve floor space).
B
on the controlRoll dripping wet articles in a towel to remove excess water.out only operates if the airflow is severely restrThe aboicted sove items can be purchased as accessories for your tumble
A
panel.make sure the filter is clean, the air inlets and outlets at
Place delicate articles e.g. tights, scarves, inside a pillowcase.dryer from your supplier.
the front and back are not blocked, and that all other
To avoid the need to iron easycare polyester/cotton items it is
restrictions are removed before re-starting.
TECHNICAL DATA
better to only dry small loads (i.e half fill drum).
If the cut-out continues to operate after checking the
It is better to dry small and large articles together.OVERALL DIMENSIONS:
above points, you should contact your service agent.
AHeight: 85 cm Width: 59.5 cm Depth: 53 cmWe suggest a fabric conditioner to be used to reduce static
B
electricity.
MAXIMUM DRY WEIGHT LOADS:
If your machine does not workcheck the following before
Do not overload the dryer or dry large bulky items such asCotton 6kg
calling a service engineer:
duvets or sleeping bags as it is important that the airflow through(for minimum creasing 2kg)
the dryer is not obstructed.Delicates 2kg
� Check that there is a supply of electricity.
Do not place items contaminated with inflammable substancesFor electrical ratings see plate on back of dryer.
� Check that the door has been properly closed and the
in the dryer, such as petrol, cleaning solvents, cooking oil, fat, orFor Model No. see serial plate inside door (needed when requesting service).
Bmachine is switched on.
Ahair lacquer.These can cause fires. For the same reason, do notRoom temperature range 5uC to 30uC.
dry rubber, foam rubber, plastic or paper.� Check the plug internal connections.Your washing machine should have a spin speed of not less than 800rpm. |
ACEC
CROSSLEE
