~-
-
m
-See the ?Control Panel? at front of the monitor. You can adjust the picture position, size,
-side pincushion, trapezoid, rotation, color balance, brightness and contrast of the
-
monitor with these buttons.
qIf two or more buttons are pressed at the same time, they will be invalid except when
mentioned in the following.
1. FUNCTION OF CONTROLS
( Power Switch [ a] 1
l Power is switched ON or OFF by pushing this button.
When the power is ON,
) The power LED will lights.
) The picture position, size, side pincushion, trapezoid, color balance, brightness,
rotation, and contrast of the monitor will be adjusted automatically.
(refer to ?Automatic Settings?)
) The contrast adjustment mode will be set, and the contrast LED will light.
q If all LEDs light continuously or the power LED blinks, make sure the power switch
of the computer, signal cable connection, and the input sync. signal are right.
The monitor will recover rapidly when the monitor receives a right sync. signal.
Degauss Button[ DEGAUSS ]
,,
STORE
0
I
l The manual degaussing function is activated by pressing this button.
) Use the degauss button only when you see color impurities on the screen after
turning the monitor ON. Remember, the monitor is automatically degaussed
during initial power on.
0 Wait for about 10 minutes before repeating the function.
70 |
ACEC
HITACHI
