HITACHI CMPAT04 Instruction Manual

4. Installing the angle
adjustment unit
1. Pass the wiring cables2.Insert 2 snap pins.
through the pipe, then insert
the angle adjustment unitCeiling mount unit
into the ceiling mount unit.
Adjust the height so that the
red mark on the pipe is not
3.Tighten the
visible and then insert the 4 lock screws.
two coupling pins.
Have two coupling pins
inserted into the linkage
holes in the angle adjustment
unit.1.Insert the
2 coupling pins
Linkage hole
2. Insert snap pins into the
holes in the ends of the
coupling pins.5.Tighten the
rotation stopper
screw.
3. Tighten the 4 lock screws.Red mark
4. Adjust the horizontal angle of
the screen.Angle adjustment unit
5. Tighten the one rotation
stopper screw.
This could cause the
plasma display to fall
if it is assembled to
make the red mark4.Adjust the
visible. horizontal angle.
Mounting the display mounting fittings on the plasma display
CMP401X
1. Remove the stand.3. Remove the 4 screws fastening the stand and
1. Place a protective sheet cover on the top of aremove the stand in the direction indicated by the
table and place the plasma display on the coverarrowmark.
with the back side upward.
2. Remove the screws fastening the column and pull
the column out in the direction indicated by the
arrowmark.
Remove 4 screws.
Remove the screws.Column
CMP401X plasma
displayStand
Stand
Table
- 7 -