Additional Information
Notes on CDs
Y Before playing a CD, clean the CD surface with a
Precautionscleaning cloth. Wipe the CD from the center out.
Y Do not play a CD with tape, stickers, or adhesives
On operating voltageon any of its surfaces as this may damage the
system.
Before operating the system, check that the operatingY Do not use solvents.
voltage of your system is identical with the voltage of
Y Do not expose the CDs to direct sunlight or heat
your local power supply.
sources.
On safety
Note on CD-R/CD-RW playback
Y The unit is not disconnected from the AC power
Discs recorded on CD-R/CD-RW drives may not be
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.played back because of scratches, dirt, recording
condition or the driverOs characteristics. Besides, the
Y Unplug the system from the wall outlet (mains) if it
discs, which are not yet finalized at the end of
will not be used for an extended period of time. To
disconnect the power cord (mains lead), pull it outrecording, cannot be played back.
by the plug. Never pull the cord itself.Music discs encoded with copyright
Y Should any solid object or liquid fall into the
protection technologies
system, unplug the system and have it checked by
qualified personnel before operating it any further.This product is designed to playback discs that
conform to the Compact Disc (CD) standard.
Y AC power cord must be changed only at the
Recently, various music discs encoded with copyright
qualified service shop.
protection technologies are marketed by some record
On placementcompanies. Please be aware that among those discs,
there are some that do not conform to the CD
Y Do not place the system in an inclined position.
standard and may not be playable by this product.
Y Do not place the system in locations where it is:
N Extremely hot or coldCleaning the cabinet
N Dusty or dirtyClean the cabinet, panel and controls with a soft cloth
N Very humidslightly moistened with mild detergent solution. Do
N Subject to vibrationsnot use any type of abrasive pad, scouring powder or
N Subject to direct sunlightsolvent such as thinner, benzene or alcohol.
Y Use caution when placing the unit or speakers on
surfaces that have been specially treated (with wax,To save a tape permanently
oil, polish, etc.) as staining or discoloration of theTo prevent a tape from being accidentally recorded
over, break off the cassette tabs from side A or side B
surface may result.
as illustrated.
On heat buildup
Y Although the unit heats up during operation, this isBreak off the
not a malfunction.cassette tab
Y Place the system in a location with adequate
ventilation to prevent heat build-up in the system.
If you continuously use this system at a large volume,
the cabinet temperature of the top, side and bottom
rises considerably. To avoid burning yourself, do not
touch the cabinet.
If you later want to reuse the tape for recording, cover
To prevent a malfunction, do not cover the ventilationthe broken tab with adhesive tape.
hole for the cooling fan.
On operation
Y If the system is brought directly from a cold place
to a warm place, or is placed in a very damp room,
moisture may condense on the lens inside the CD
player. Should this occur, the system will not
operate properly. Remove the CD and leave the
system turned on for about an hour until the
moisture evaporates.
Y When moving the unit, remove any disc that may be
on the disc tray.
If you have any questions or problems concerning
your system, please consult your nearest Sony dealer.
20 |
ACEC
SONY
