On operation
If the system is brought directly from a cold to a
Additional Informationwarm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD
Precautionsplayer. Should this occur, the system will not operate
properly. Remove the disc and leave the system
turned on for about an hour until the moisture
On operating voltage
evaporates.
Before operating the system, check that the operating
When you move the system, take out any disc.
voltage of your system is identical with the voltage of
your local power supply.
If you have any questions or problems concerning your
On safetysystem, please consult your nearest Sony dealer.
The unit is not disconnected from the AC power
Notes on discs
source (mains) as long as it is connected to the wall
Before playing, clean the disc with a cleaning cloth.
outlet, even if the unit itself has been turned off.
Wipe the disc from the center out.
Unplug the system from the wall outlet (mains) if it
Do not use solvents such as benzene, thinner,
is not to be used for an extended period of time. To
commercially available cleaners or anti-static spray
disconnect the power cord (mains lead), pull it out by
intended for vinyl LPs.
the plug. Never pull the cord itself.
Do not expose the disc to direct sunlight or heat
Should any solid object or liquid fall into the system,
sources such as hot air ducts, nor leave it in a car
unplug the system and have it checked by qualified
parked in direct sunlight.
personnel before operating it any further.
Do not use discs encircled with a protection ring.
AC power cord must be changed only at the qualified
This may cause a malfunction to the system.
service shop.
When using discs that have glue or similar tacky
On placementsubstance on the label side of the disc or that used a
Do not place the system in an inclined pospsiectiiaonl .ink when the label was printed, there is a
Do not place the system in locations wherceh aintc is;e that the disc or label may become attached to
- Extremely hot or coldparts inside this unit. When this occurs, it may not be
- Dusty or dirtypossible to remove the disc, and may also cause this
unit to malfunction. Be sure to check that the label
- Very humid
side of the disc is not sticky before using.
- Subject to vibrations
The following types of disc should not be used:
- Subject to direct sunlight.
- Rental or used discs with attached seals where the
Use caution when placing the unit or speakers on
glue extends beyond the seal. The perimeter of the
surfaces that have been specially treated (with wax,
seal on the disc is tacky.
oil, polish, etc.) as staining or discoloration of the
- Discs that have labels printed using a special ink
surface may result.
that feels tacky when touched.
On heat buildup Discs with non-standard shapes (e.g., heart, square,
Although the system heats up during operasttiaon,r) c tahnnisot be played on this unit. Attempting to do
is not a malfunction.so may damage the unit. Do not use such discs.
Place the system in a location with adequate
Notes on CD-R and CD-RW
ventilation to prevent heat build-up in the system.
This system can play CD-R/CD-RW discs edited by
If you continuously use this system at a high volume,
the user. However, note that playback of some discs
the cabinet temperature of the top, side and bottom
may not be possible depending on the recording
rises considerably. To avoid burning yourself, do not
device used for recording or the disc condition.
touch the cabinet.
CD-R and CD-RW discs that have not been finalized
To prevent a malfunction, do not cover the
(processing to allow play by a normal CD player)
ventilation hole.
cannot be played.
CD-R and CD-RW discs recorded in multi-session
mode are not supported.
GB
22 |
ACEC
SONY
