Step 1: Hooking up the systemTip
(continued)If you use the system with the speakers detached, you
may remove the four screws on the both sides of the
unit. If you do, be sure to retain the screws for future
6Connect the power cord to a wall outlet.use.
If the plug does not fit the wall socket,
detach the supplied plug adaptor (only for
models equipped with an adaptor).+�
Note
Do not attempt to lift up the system by the speakers.
There is a chance the unit will detach and drop. To
move the system, detach the speakers first and carry
them separately.To replace the speaker grille
Note on the glass door of the CDTo remove the speaker grille, grasp one of the corners
and lift the grille out towards you. You can replace
playerthe grille with one of the other supplied grilles of a
The CD player door is made of tempered glass.different color.
Under normal conditions, this tempered glass isVerify which sides of the grille are rounded, then
more shock resistant and able to bear more weightattach the grille with the rounded sides on the top and
than ordinary glass. This glass, however, maythe bottom.
shatter if it receives a sharp blow or if it is
scratched.To remove the AM antenna
If noise is heard while listening to an AM station,
remove the AM antenna from the rear panel and
To detach the speakersplace the antenna outside.
1 Slide the speakers in the opposite direction of
1 Remove the rear cover. (see step 1 on the
the arrows of the illustration in OAttach thepage 4).
speakers� (see step 2-3 on page 5).
2 After detaching the speakers, pass the speaker2 Remove the AM antenna.
cords through the speaker cord slot at the
bottom of the speaker to prevent them from
being damaged.
Slot
6 |
ACEC
SONY
