Operating modes - TV
3
Removing the CI module Searching for new software
1. Switch the TV set off by pulling If you want to carry out a manual search for new software, proceed as follows:
the mains plug from the power outlet.
1. Call the TV menu using the MENU button.
2. Remove the cover from the back of the set
2. ConŢ rm the ?Settings? using OK.
on the upper left.
FACE
3. Press the eject button at the module slot; 3. ConŢ rm the ?Miscellaneous? using OK.
the module is unlocked.
4. Remove the module from the set.CI module4. Select ?DVB software? and press OK.
COMMON INTER
Update digital TV software
3
Inserting a new CI module Current version: V3.x.x
You can search for a new software version with OK.
After you insert a new CI module and switch the TV
set on, the following dialogue is displayed:
5. If you start the search using OK, the set checks if there is a new software
Autom. station search
version available.
Your TV set has detected a new CI module. This requires a station
search for all new receivable stations.
6. If there is a new version available, the set generates an on-screen message.
After you press the OK button, the system starts the wizard to carry out the Update digital TV software
automatic station search.Current version: V3.x.x
Check the proposed search parameters and let the set search for new stations.New version: V3.1.0
Calling the CI module menu
Downloading software
Here you can call up information on the inserted common interface module and
the smartcard. To do this, use the MENU button to call the TV menu, select the 1. If you press OK in the dialogue above, you can decide whether you want to
line ?Settings?, ?Miscellaneous? and then the entry ?CI module - xxx? (in place download the new software immediately, when you switch off the set or not
of ?xxx? stands the name of the provider which is output by the smartcard. The at all. We recommend you always carry out the update of the digital software.
This is the only way to ensure your set is always up to date.
content of this menu depends on the particular supplier of the CI module.
Note: This menu is only available for digital stations2. If you do decide to update, the software is initialised on your set and you are
informed of the status with a grey bar.
Installing new DVB softwareDo not switch your set off during this time. This process may take up
to one hour. You will be informed when the process is completed.
To ensure your DVB-S receiver is always performing at the state of the art, newly
developed software versions are made available from time to time; these are 3. After the software is updated, you will be asked to switch your TV set off and
back on again using the on/standby switch.
broadcast via satellite and can be automatically installed on your set (only pos-
sible via ASTRA1).
If the update was not carried out, you will be asked several times when you
Software is recognised automatically switch on the set whether you want to carry out this update.
The set can determine whether a new software version is available. This occurs
at night when your EPG is automatically updated. For this, your TV set has to re-
main in the standby mode (do not switch off using the on/off button on the set).
If a new software version has been found, the set will indicate this with an on-
screen message the next time the set is switched on: You can decide whether or
not you want to download the new software.
ConŢ rm using OK, so that the new software can be loaded and installed via
satellite. Continue as set out in the ?Downloading software? section.
21 - |
ACEC
LOEWE
