7
Operating instructions
Changing the menu language Display set-up
1. Press the yellow button to select the Vision menu.Program number HIDE
Volume bar SHOW
2. Press the red button to select the Display set-up menu.Menu language ENGLISH
3. Change the menu language with cursor buttons.Sharpness
Tint
4. Press the OK button to store the changes.
5. Press the TV button to exit. Go back Store ?
Manual tuning Menu
1. Select the programme number you want to tune.
Timers
2. Press the MENU button. Front panel lock
Locking
3. Select OTuning� and press the OK button. Tuning
Sort programs
4. Select OManual tuning� and press the OK button. Programme settings
5. Press the red button (Channel search). Press ?
6. Press the OK button to store.
Go back
7. Press the TV button to exit.
APSi (Automatic Programming System) Tuning
1. Press the MENU button.
2. Select OTuning� and press the OK button. Automatic retuning
Add new programs
3. Select OAutomatic retuning� and press the OK button. Manual tuning
External units
4. To retune the channels, press the red button. Copy tuning to VCR
Copy tuning from VCR
5. Press the TV button to exit. Clear all programs
Press ?
Go back
Initialization of NVRAM
Initialization of NVRAM (ICf2)
In case that the NVRAM is replaced, it must be initialized3c. If automatic initialization did not happen, you can
and configured.start it manually by entering the key code: BLUE (wait
1. Switch the TV set to stand-by mode.approx. 2 s.), 2, 5, 4 (wait approx. 2 s.) and OK.
Press e- (volume minus) button on local control unitInitializing will take about 15 s.
and at the same time start entering password: MENU,4. Switch off the receiver by pressing the mains switch.
TV and i with the remote control. Release e- button5. Start the receiver in TV mode by pressing the mains
after the MENU button is pressed. The record led willswitch. Tune in one or more tv channels.
light up to indicate that service mode is enabled.6. Switch off the receiver with remote control.
2. Press the RED-button to pre-configure the set. Green7. Enter service mode and make the service adjustments
2
led will flash once to indicate this.(see section "SERVICE ADJUSTMENTS VIA IC BUS").
3a. At the same time the controller will check NVRAM8. Switch off the receiver by pressing the mains switch.
and initialize it automatically if it was Oempty�.
Initializing will take about 15 s. When it is completed,
the green led will light up. Continue to step 4.
3b.Automatic initialization did not happen if the green
led does not light up steadily. In some cases the led
might also light up immediately after configuration
without any initializing, depending on NVRAM
contents. In this case it might be enough to store the
new configuration by pressing OOK�. Continue to
step 4. |
ACEC
HITACHI
