On-screen messages
Troubleshooting
If there is something wrong with the input signal, one of the
Before contacting technical support, refer to this sefollocwtioing men.ssages appears on the screen.
If NO INPUT SIGNAL appears on the screen
If thin lines appear on your screen
INFORMAT ION
(damper wires)MON I TOR I S WORK I NG
I NPUT: 68.7kHz /8z5 H
NO I NPUTS IGNAL
The lines you are experiencing on your screen are normal for the
Trinitron monitor and are not a malfunction. These are shadows
from the damper wires used to stabilize the aperture grille anWHd aITEre
most noticeable when t?hse b scackreenground is light (usually RED
GREEN
white). The aperture grille is the essential element that makBLes a UE
Trinitron picture tube unique by allowing more light to reach the
screen, resulting in a brighter, more detailed picture.
1111 The frequencies of the current input signal
Damper wiresIf the monitor recognizes the frequencies of the current input
signal, the horizontal and vertical frequencies are displayed.
2222 The input signal condition
NO INPUT SINGAL
This indicates that no signal is input.
If OUT OF SCAN RANGE appears on the screen
INFORMAT ION
USMON I TOR I S WORK I NG
I NPUT: 130.0kHz /75 zH
OUT OF SCAN RANGE
CHANGE S IGNAL T IMI NG
WH I TE
RED
GREEN
BLUE
1111 The frequencies of the current input signal
If the monitor recognizes the frequencies of the current input
signal, the horizontal and vertical frequencies are displayed.
2222 The input signal condition
OUT OF SCAN RANGE
This indicates that the input signal is not supported by the
monito?sr specifications.
3333 The remedies
CHANGE SIGNAL TIMING appears on the screen. If you
are replacing an old monitor with this monitor, reconnect the
old monitor. Then adjust t?s grhe coapmphiutc boer ard so that
the horizontal frequency is between 30 - 109 kHz, and the
vertical frequency is between 48 - 160 Hz.
For more informatio?Tn, seroublee symptoms and re? onmed ies
page 16
15 |
ACEC
SONY
