CP-X270W
Lamp
HIGH VOLTAGE
HIGH TEMPERATURE
HIGH PRESSURE
Contact your dealer before replacing the lamp.
(Option lamp: DT00301)
Before replacing the lamp, switch power OFF, remove the power cord from the power outlet, and wait
approximately 45 minutes until the lamp has cooled. The lamp may explode if handled at high temperatures.
WARNING
Lamp
For disposal of used lamp, treat according to the instruction of community
authorities.
Since the lamp is made of glass, do not apply shock to it and do not
scratch it.
Also, do not use old lamp. This could also cause explosion of the lamp.
If it is probable that the lamp has exploded (explosive sound is heard),ReflectorFront
glasss
disconnect the power plug from the power outlet.
The lamp is covered by front glass , but, in rare cases, the reflector and the inside of the projector
may be damaged by scattered broken pieces of glass, and broken pieces could cause injury when
being handled.
Lamp Life
Projector lamps have a finite life. The image will become darker, and hues will become weaker, after a lamp has
been used for a long period of time.
Replace the lamp if the LAMP indicator is red, or the CHANGE THE LAMP message appears when the projector is
switched ON.
NOTE:
The LAMP indicator is also red when the lamp unit reaches high temperature. Before replacing the lamp, switch
power OFF, wait approximately 20 minutes, and switch power ON again. If the LAMP indicator is still red, replace
the lamp.
-- 19 -- |
ACEC
HITACHI
