E
NTroubleshooting(continued)
G
L
I
SÂ Radio
H
TroubleCause / Step
31
Station is too far, or signals are too weak.
aSelect other stations of higher signal level.
Much noise in FMThe radio antenna is not extended enough.
stereo and monauralaExtend the radio antenna enough.
broadcasts
The motor antenna relay control lead is not connected correctly.
a If there is a motor antenna in the car, connect the motor antenna relay control
lead to the motor antenna lead that is installed in the car correctly.
Battery cable is not correctly connected.
Preset station is reset.
aConnect the battery cable to the terminal that is always live.
 CD
TroubleCause / Step
CD is upside down.
CD is in the CD com-
aPlace CD in the correct direction with the label side up.
partment but no sound
is made, or CD is eject-
CD is dirty.
ed automatically.
aClean CD, referring to the section on Notes on CD.
CD sound skips, toneCD is dirty.
quality is low.aClean CD, referring to the section on Notes on CD.
Mounting angle is over 30 degrees.
aAdjust mounting angle to less than 30 degrees.
Sound skip due to
vibration
Unstable mounting
aMount the unit securely with the mounting parts, referring to the section
on Installation.
!CD is defective.
!Mechanical trouble
aOpen the panel and press [u] (CD EJECT). If failure persists, press the
CD is not ejected.reset switch. If normal operation is not restored, call the store where you
purchased the unit or the nearest Panasonic Service Center to ask for
repairs.
 Cassette Tape
TroubleCause / Step
Blank tape is inserted in the unit.
No sound
aInsert recorded tape into the unit.
Heads are dirty.
aClean Heads. (Ask a service representative for advice.)
Tape sound quality is
poor.
Poor quality tape.
aUse better quality tape.
40
CQ-VX2200W |
ACEC
PANASONIC
