QC13OegM9% 02/05 :9P Â?
Caution
Observe the following cautions when using thisQDo not install the product where it is exposed to strong
vibrations or is unstable.
unit.Avoid slanted or strongly curved surfaces for installation. If the
QKeep the sound volume at an appropriate level.installation is not stable, the unit may fall down while driving and
Keep the volume level low enough to be aware of road and trafficthis can lead to an accident or injury.
conditions while driving.QInstallation Angle
QThis unit is designed for use exclusively in automo-The product should be installed in a horizontal position with the
biles.front end up at a convenient angle, but not more than 30ű.
QDo not operate the unit for a prolonged period with theThe user should bear in mind that in some areas there may be
engine turned off.restrictions on how and where this unit can be installed. Consult
Operating the audio system for a long period of time with theyour dealer for further details.
engine turned off will drain the battery.QWear gloves for safety. Make sure that wiring is com-
QDo not expose the unit to direct sunlight or excessivepleted before installation.
heat.QTo prevent damage to the unit, do not connect the
Otherwise these will raise the interior temperature of the unit,power connector until the whole wiring is completed.
and it may lead to smoke, fire, or other damage to the unit.QDo not connect more than one speaker to one set of
QDo not use the product where it is exposed to water,speaker leads. (except for connecting to a tweeter)
moisture, or dust.
Exposure of the unit to water, moisture, or dust may lead to
smoke, fire, or other damage to the unit. Make especially sure
that the unit does not get wet in car washes or on rainy days.
Observe the following cautions when installing.
QRefer wiring and installation to qualified service per-
sonnel.
Installation of this unit requires special skills and experience. For
maximum safety, have it installed by your dealer. Panasonic is
not liable for any problems resulting from your own installation
of the unit.
QFollow the instructions to install and wire the product.
Not following the instructions to properly install and wire the
product could cause an accident or fire.
QTake care not to damage the leads.
When wiring, take care not to damage the leads. Prevent them
from getting caught in the vehicle chassis, screws, and moving
parts such as seat rails. Do not scratch, pull, bend or twist the
leads. Do not run them near heat sources or place heavy objects
on them. If leads must be run over sharp metal edges, protect
the leads by winding them with vinyl tape or similar protection.
QUse the designated parts and tools for installation.
Use the supplied or designated parts and appropriate tools to
install the product. The use of parts other than those supplied or
designated may result in internal damage to the unit. Faulty
installation may lead to an accident, a malfunction or fire.
QDo not block the air vent or the cooling plate of the unit.
Blocking these parts will cause the interior of the unit to over-
heat and will result in fire or other damage.
The following applies only in the U.S.A.
Caution
Part 15 of the FCC RulesTHIS PRODUCT IS A CLASS I LASER PRODUCT.
FCC Warning:
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAYAny unauthorized changes or modifications to this equipment
RESULT IN HAZARDOUS RADIATION EXPOSURE.would void the user's authority to operate this device.
DO NOT OPEN COVERS AND DO NOT REPAIR BY YOURSELF.
REFER SERVICING TO QUALIFIED PERSONNEL. |
ACEC
PANASONIC
