EE
Installation (continued)Anti-Theft System
NN
GG
LL
II
To Remove the Unit2OpenThis unit is equipped with a removable face plate. Removing
SContactS
Removable Face Plate Case
this face plate makes the radio totally inoperable.
Hq Switch off the power of the unit.H
q
w Press [OPEN]. The removable face plate
2122
will be opened.Place Removable Face Plate into
Case
[OPEN]
OPENq Switch off the power of the unit.
4
Pull out
e Push the face plate to either the right orw Remove the removable face plate. (aPrevious page)
left.
Push
3
r Pull it out toward you.eGently press the bottom of the case and open the cover.
Place the face plate into the case and take it with you when
you leave the car.
wRemove the trim plate rwith a screwdriver.r Trim Plate
Screwdriver
Contact
Install Removable Face Plate
1q Fit the face plate with its left hole on the left pins provided
on the main unit.
2
3
w Fit the other hold on the other pin applying slight pressure.2
e Move the face plate up and down a few times to make sure
ePull out the unit while pushing down the lock
it is secure. Then close the front panel and press down the
lever with the lock cancel plate t.
right side of the face plate until it clicks into plate.
1
1Insert
Security Indicator
Insert the tab
t Lock Cancel PlateThe security indicator blinks when the removable face plate is
end in the
outer groove.removed from the unit.
This function is activated when the Security Function is ON.
(a Page 24)
Panel Removal Alarm
Security Indicator
This alarm sounds to warn you not to forget to remove the
2Pull out
OClick�panel before leaving your car.
This function is activated when the Security Function is ON.
(a Page 24)
rRemove the unit pulling with both hands.
Caution:
! This face plate is not waterproof. Do not expose it to water or excessive moisture.
! Do not remove the face plate while driving your car.
! Do not place the face plate on the dashboard or nearby areas where the temperature rises to high level.
Caution:
! Do not touch the contacts on the face plate or on the main unit, since this may result in poor electrical contacts.
!Do not touch the contacts on the face plate or on the main unit, since this may result in poor electrical contacts.
! If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth.
!If dirt or other foreign substances get on the contacts, wipe them off with clean and dry cloth.
! To avoid damaging the front panel, do not push it down or place objects on it while it is open.
2829
CQ-C3400/C3300/C3100WCQ-C3400/C3300/C3100W |
ACEC
PANASONIC
