Safety Information
or designated may result in internal damage to the unit. Faulty
Cautioninstallation may lead to an accident, a malfunction or re.
Observe the following cautions when using this o Do not block the air vent or the cooling plate of the
unit.unit.
o Keep the sound volume at an appropriate level.Blocking these parts will cause the interior of the unit to
Keep the volume level low enough to be aware of road and overheat and will result in re or other damage.
Englishtrafc conditions while driving.o Do not install the product where it is exposed to
o This unit is designed for use exclusively in automobiles. strong vibrations or is unstable.
o Do not operate the unit for a prolonged period with Avoid slanted or strongly curved surfaces for installation.
If the installation is not stable, the unit may fall down while
the engine turned off.
Operating the audio system for a long period of time with the driving and this can lead to an accident or injury.
engine turned off will drain the battery.o Installation Angle
The product should be installed in a horizontal position with
o Do not expose the unit to direct sunlight or
excessive heat.the front end up at a convenient angle, but not more than
Otherwise these will raise the interior temperature of the 30�.
The user should bear in mind that in some areas there may
unit, and it may lead to smoke, re, or other damage to the
unit.be restrictions on how and where this unit must be installed.
Consult your dealer for further details.
o Do not use the product where it is exposed to water, o Wear gloves for safety. Make sure that wiring is
moisture, or dust.
Exposure of the unit to water, moisture, or dust may lead to completed before installation.
o To prevent damage to the unit, do not connect the
smoke, re, or other damage to the unit. Make especially sure
that the unit does not get wet in car washes or on rainy days. power connector until the whole wiring is completed.
o Set the volume level to low enough before the AUX o Do not connect more than one speaker to one set of
connection is completed. speaker leads. (except for connecting to a tweeter)
Failure to observe this, the loud noise may come out and Observe the following cautions when handling Safety Information
damage your speakers and your hearing. Direct connection the battery for the remote control unit.
of the speaker/headphone output of an external device Use only specied battery (CR2025).
without any attenuator may distort sound or damage the
Match the polarity of the battery with the (_ ) and (` ) marks
connected external device. in the battery case.
Observe the following cautions when Replace a dead battery as soon as possible.
installing. Remove the battery from the remote control unit when not
o Refer wiring and installation to qualied service personnel. using it for an extended period of time.
Insulate the battery (by placing them in a plastic bag or
Installation of this unit requires special skills and experience.
For maximum safety, have it installed by your dealer. covering them with vinyl tape) before disposal or storage.
Panasonic is not liable for any problems resulting from your Dispose of the battery according to the local regulations.
own installation of the unit. Do not disassemble, recharge, heat or short the battery. Do
o Follow the instructions to install and wire the product.not throw a battery into a re or water.
Not following the instructions to properly install and wire the In case of battery leakage
Thoroughly wipe the battery liquid off the battery case and
product could cause an accident or re.
o Take care not to damage the leads.insert new battery.
When wiring, take care not to damage the leads. Prevent If any part of your body or clothing comes into contact with
battery liquid, wash it with plenty of water.
them from getting caught in the vehicle chassis, screws, and
moving parts such as seat rails. Do not scratch, pull, bend If battery liquid comes into contact with your eyes, wash
or twist the leads. Do not run them near heat sources or them with plenty of water and get immediate medical
attention.
place heavy objects on them. If leads must be run over sharp
metal edges, protect the leads by winding them with vinyl
tape or similar protection.
o Use the designated parts and tools for installation.
Use the supplied or designated parts and appropriate tools to
install the product. The use of parts other than those supplied
CQ-C500U3 |
ACEC
PANASONIC
