EE
NN
GInstallation Guide (continued)G
LL
II
SS
HInstallation ProceduresRemove the UnitH
49First complete the electrical connections, and then The included mounting collar 1 is designed Switch off the power of the unit.50
check them for correctness (page 70).speciŢ cally for this unit. Do not use it to attach
Remove the removable face plate (page 63).
any other model.
Remove the 17 Trim plate
mounting collar 1
Insert mounting collar 1 into the
and the trim plate 7 1Screwdriver
dashboard, and bend the mounting tabs out
from the main unit Remove the trim plate 7 with a screwdriver.
with a screwdriver.
temporarily, which 2
are already mounted The tabs to be bent vary depending on
at shipment.the car. To securely install the unit, fully
bend a number of the tabs so that there is
6 Power no rattling.1 Insert the lock cancel plates 8 along the
connector3grooves on both sides of the main unit 1 Insert.
Example:
Mounting until Oclick� is heard.
Insert the tab
springs (§ )Tab
2 Pull out the unit while pushing the plates end in the
further inside.outer groove.
8 Lock cancel plate
Secure the rear of the unit.
OClick�
2
After Ţ xing mounting bolt 5 and power
Mounting holesconnector 6 , Ţ x the rear of the unit to the
car body by either method (a) or (b) shown
5 Mounting boltbelow.
Insert trim plate 7 .
3
2 Pull out.
After installation,
Engage the mounting
4
reconnect the Remove the unit pulling with both hands.
springs (§ ) in the
negative - battery 4
mounting holes of the
Mounting terminal.
mounting collar 1
Å¢ rmly.hole
Mounting springs (§ )
(a) Using the rear support strap 3(b) Using the rubber cushion (option)
Fire wall of car
Rear support bracket
Rubber cushion (option)(provided on the car)
4 Tapping screw3 mm�
2 Hex. nut
3 Rear support strap
5 Mounting bolt
5 Mounting bolt1 Mounting collar
1 Mounting collar
6869
CQ-C9800/9700UCQ-C9800/9700U |
ACEC
PANASONIC
