R Do not install the product where it is exposed to strong
Cautionvibrations or is unstable.
Observe the following cautions when using this Avoid slanted or strongly curved surfaces for installation. If the
unit.installation is not stable, the unit may fall down while driving and
this can lead to an accident or injury.
R Keep the sound volume at an appropriate level.
R Installation Angle
Keep the volume level low enough to be aware of road and traf c
The product should be installed in a horizontal position with the
conditions while driving.
front end up at a convenient angle, but not more than 30�.
R This unit is designed for use exclusively in automobiles.The user should bear in mind that in some areas there may be
R Do not operate the unit for a prolonged period with the restrictions on how and where this unit must be installed. Consult
engine turned off.your dealer for further details.
Operating the audio system for a long period of time with the R Wear gloves for safety. Make sure that wiring is
engine turned off will drain the battery.completed before installation.
R Do not expose the unit to direct sunlight or excessive R To prevent damage to the unit, do not connect the power
heat.connector until the whole wiring is completed.
Otherwise these will raise the interior temperature of the unit, and R Do not connect more than one speaker to one set of
it may lead to smoke, re, or other damage to the unit.speaker leads. (except for connecting to a tweeter)
R Do not use the product where it is exposed to water,
Observe the following cautions when handling the
moisture, or dust.
Exposure of the unit to water, moisture, or dust may lead to battery for the remote control unit.
smoke, re, or other damage to the unit. Make especially sure that Use only speci ed battery (CR2025).
the unit does not get wet in car washes or on rainy days. Match the polarity of the battery with the (+) and () marks in the
R Set the volume level to low enough before the AUX battery case.
connection is completed. Replace a dead battery as soon as possible.
Failure to observe this, the loud noise may come out and damage Remove the battery from the remote control unit when not using it
for an extended period of time.
your speakers and your hearing. Direct connection of the speaker/
Insulate the battery (by placing them in a plastic bag or covering
headphone output of an external device without any attenuator
them with vinyl tape) before disposal or storage.
may distort sound or damage the connected external device.
Dispose of the battery according to the local regulations.
Observe the following cautions when installing. Do not disassemble, recharge, heat or short the battery. Do not
RRefer wiring and installation to quali ed service personnel.throw a battery into a re or water.
Installation of this unit requires special skills and experience. For In case of battery leakage
maximum safety, have it installed by your dealer. Panasonic is not liable Thoroughly wipe the battery liquid off the battery case and insert
for any problems resulting from your own installation of the unit.new battery.
R Follow the instructions to install and wire the product. If any part of your body or clothing comes into contact with battery
Not following the instructions to properly install and wire the liquid, wash it with plenty of water.
product could cause an accident or re. If battery liquid comes into contact with your eyes, wash them with
R Take care not to damage the leads.plenty of water and get immediate medical attention.
When wiring, take care not to damage the leads. Prevent them
Observe the following cautions when using USB
from getting caught in the vehicle chassis, screws, and moving
device.\CQ-RX400U\
parts such as seat rails. Do not scratch, pull, bend or twist the
Do not connect a USB device directly to this unit. If the USB device
leads. Do not run them near heat sources or place heavy objects
on them. If leads must be run over sharp metal edges, protect the is connected directly to this unit and an accident occurs, or if the
leads by winding them with vinyl tape or similar protection.brakes are applied suddenly, the driver or passenger may bump
into the USB device and may get injured.
R Use the designated parts and tools for installation.
Position the USB device and USB extension cable so that they do
Use the supplied or designated parts and appropriate tools to
not obstruct your driving.
install the product. The use of parts other than those supplied
or designated may result in internal damage to the unit. Faulty Do not connect any USB device other than USB memory, a USB
installation may lead to an accident, a malfunction or re. audio player or iPod series. Do not connect multiple USB devices
to the USB connector. Drawing power for multiple USB devices
RDo not block the air vent or the cooling plate of the unit.
from the connector could cause overheating and smoking.
Blocking these parts will cause the interior of the unit to overheat
and will result in re or other damage.
The following applies only in the U.S.A.
CautionPart 15 of the FCC Rules
THIS PRODUCT IS A CLASS I LASER PRODUCT.FCC Warning:
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF Any unauthorized changes or modi cations to this equipment would
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY void the users authority to operate this device.
RESULT IN HAZARDOUS RADIATION EXPOSURE.
DO NOT OPEN COVERS AND DO NOT REPAIR BY YOURSELF.
Notice
REFER SERVICING TO QUALIFIED PERSONNEL.
This product contains a CR Coin Cell Lithium Battery which contains
Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate.
- 8 - |
ACEC
PANASONIC
