Safety Information
 Read the operating instructions for the unit and all other com- This manual uses pictographs to show you how to use the
QDo not install the product where it is exposed to
ponents of your car audio system carefully before using theproduct safely and to alert you to potential dangers resultingCaution
strong vibrations or is unstable.system. They contain instructions about how to use the sys-from improper connections and operations. The meanings of
Englishtem in a safe and effective manner. Panasonic assumes nothe pictographs are explained below. It is important that youObserve the following cautions when using thisAvoid slanted or strongly curved surfaces for installation. IfEnglish
responsibility for any problems resulting from failure tofully understand the meanings of the pictographs in order tothe installation is not stable, the unit may fall down while
unit.driving and this can lead to an accident or injury.
observe the instructions given in this manual.use this manual and the system properly.
1QInstallation Angle2
QKeep the sound volume at an appropriate level.
Keep the volume level low enough to be aware of road andThe product should be installed in a horizontal position with
traffic conditions while driving.the front end up at a convenient angle, but not more than
This pictograph intends to alert you to the pres-This pictograph intends to alert you to the pres-
30u.
ence of important operating instructions andence of important operating instructions andQDo not insert or allow your hand or fingers to be
The user should bear in mind that in some areas there may
installation instructions. Failure to heed theinstallation instructions. Failure to heed thecaught in the unit.
WarningCautionbe restrictions on how and where this unit must be installed.
instructions may result in severe injury or death.instructions may result in injury or material dam-To prevent injury, do not get your hand or fingers caught in
Consult your dealer for further details.
age.moving parts or in the disc slot. Especially watch out for
infants.QWear gloves for safety. Make sure that wiring is
QThis unit is designed for use exclusively in automo-completed before installation.
biles.QTo prevent damage to the unit, do not connect the
Observe the following warnings whenQDo not operate the unit for a prolonged period withpower connector until the whole wiring is complet-
Warning
installing.the engine turned off.ed.
Observe the following warnings when usingOperating the audio system for a long period of time with theQDo not connect more than one speaker to one set of
QDisconnect the lead from the negative (�) battery
engine turned off will drain the battery.speaker leads. (except for connecting to a tweeter)
this unit.terminal before installation.
QDo not expose the unit to direct sunlight or exces-
Wiring and installation with the negative (�) battery terminal
QThe driver should neither watch the display norObserve the following cautions when handling
sive heat.
connected may cause electrical shock and injury due to a
operate the system while driving.Otherwise these will raise the interior temperature of thethe battery for the remote control unit.
short circuit.
Watching the display or operating the system will distractunit, and it may lead to smoke, fire, or other damage to theIUse only specified battery (CR2025).
Some cars equipped with the electrical safety system have
the driver from looking ahead of the vehicle and can causeunit.IMatch the polarity of the battery with the (+) and (�) marks
specific procedures of battery terminal disconnection.
accidents. Always stop the vehicle in a safe location and usein the battery case.
FAILURE TO FOLLOW THE PROCEDURE MAY LEAD TO THEQDo not use the product where it will be exposed to
the parking brake before watching the display or operatingIReplace a dead battery as soon as possible.
UNINTENDED ACTIVATION OF THE ELECTRICAL SAFETYwater, moisture, or dust.
the system.IRemove the battery from the remote control unit when not
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE ANDExposure of the unit to water, moisture, or dust may lead to
QUse the proper power supply.smoke, fire, or other damage to the unit. Make especiallyusing it for an extended period of time.
PERSONAL INJURY OR DEATH.
This product is designed for operation with a negativesure that the unit does not get wet in car washes or on rainyIInsulate the battery (by placing them in a plastic bag or cov-
QNever use safety-related components for installa-
grounded 12 V DC battery system. Never operate this prod-ering them with vinyl tape) before disposal or storage.
days.
tion, grounding, and other such functions.
uct with other battery systems, especially a 24 V DC batteryIDispose of the battery according to the local regulations.
Do not use safety-related vehicle components (fuel tank,
system.Observe the following cautions whenIDo not disassemble, recharge, heat or short the battery. Do
brake, suspension, steering wheel, pedals, airbag, etc.) for
QKeep batteries and insulation film out of reach ofinstalling.not throw a battery into a fire or water.
wiring or fixing the product or its accessories.
infants.QRefer wiring and installation to qualified serviceIn case of battery leakage
QInstalling the product on the air bag cover or in a
Batteries and insulation film can be ingested, so keep thempersonnel.IThoroughly wipe the battery liquid off the battery case and
location where it interferes with airbag operation is
out of the reach of infants. If an infant ingests a battery orinsert new battery.
Installation of this unit requires special skills and experience.
prohibited.
insulation film, please seek immediate medical attention.For maximum safety, have it installed by your dealer.IIf any part of your body or clothing comes into contact with
Q
QProtect the Deck Mechanism.Check for piping, gasoline tank, electric wiring, andPanasonic is not liable for any problems resulting from yourbattery liquid, wash it with plenty of water.
Do not insert any foreign objects into the slot of this unit.other items before installing the product.own installation of the unit.IIf battery liquid comes into contact with your eyes, wash
If you need to open a hole in the vehicle chassis to attach orthem with plenty of water and get immediate medical atten-
QDo not disassemble or modify the unit.QFollow the instructions to install and wire the prod-
wire the product, first check where the wire harness, gaso-tion.
Do not disassemble, modify the unit or attempt to repair theuct.
line tank, and electric wiring are located. Then open the hole
product yourself. If the product needs to be repaired, consultNot following the instructions to properly install and wire the
from outside if possible.
your dealer or an authorized Panasonic Servicenter.product could cause an accident or fire.
QNever install the product in a location where it inter-
QDo not use the unit when it is out of order.QTake care not to damage the leads.
feres with your field of vision.
If the unit is out of order (no power, no sound) or in anWhen wiring, take care not to damage the leads. Prevent
abnormal state (has foreign objects in it, is exposed toQNever have the power cord branched to supply otherthem from getting caught in the vehicle chassis, screws, and
water, is smoking, or smells), turn it off immediately andequipment with power.moving parts such as seat rails. Do not scratch, pull, bend or
consult your dealer.QAfter installation and wiring, you should check thetwist the leads. Do not run them near heat sources or place
QThe remote control unit should not lie about in thenormal operation of other electrical equipment.heavy objects on them. If leads must be run over sharp
car.The continuation of their using in abnormal conditions maymetal edges, protect the leads by winding them with vinyl
If the remote control unit lies about, it could fall on the floorcause fire, electrical shock or a traffic accident.tape or similar protection.
while driving, get wedged under the brake pedal, and lead toQIn the case of installation to an airbag-equippingQUse the designated parts and tools for installation.
a traffic accident.car, confirm warnings and cautions of the vehicleUse the supplied or designated parts and appropriate tools
QRefer fuse replacement to qualified service person-manufacturer before installation.to install the product. The use of parts other than those sup-
nel.QMake sure the leads do not interfere with driving orplied or designated may result in internal damage to the unit.
When the fuse blows out, eliminate the cause and have itgetting in and out of the vehicle.Faulty installation may lead to an accident, a malfunction or
replaced with the fuse prescribed for this unit by a qualifiedfire.
QInsulate all exposed wires to prevent short circuit-
service engineer. Incorrect replacement of the fuse may leadQDo not block the air vent or the cooling plate of the
ing.
to smoke, fire, and damage to the product.unit.
Blocking these parts will cause the interior of the unit to
overheat and will result in fire or other damage.
23CQ-VD7001UCQ-VD7001U |
ACEC
PANASONIC
