QTake care not to damage the leads.
Caution
When wiring, take care not to damage the leads. Prevent
them from getting caught in the vehicle chassis, screws,
Observe the following cautions when usingEnglish
and moving parts such as seat rails. Do not scratch, pull,
this unit.bend or twist the leads. Do not run them near heat sources
or place heavy objects on them. If leads must be run over2
QKeep the sound volume at an appropriate level.
sharp metal edges, protect the leads by winding them with
Keep the volume level low enough to be aware of road and
vinyl tape or similar protection.
traffic conditions while driving.
QUse the designated parts and tools for installation.
QDo not insert or allow your hand or fingers to be
Use the supplied or designated parts and appropriate tools
caught in the unit.
to install the product. The use of parts other than those
To prevent injury, do not get your hand or fingers caught in
supplied or designated may result in internal damage to the
moving parts or in the disc slot. Especially watch out for
unit. Faulty installation may lead to an accident, a malfunc-
infants.
tion or fire.
QThis unit is designed for use exclusively in auto-
Q
mobiles.Do not block the air vent or the cooling plate of the
unit.
QDo not operate the unit for a prolonged period with
the engine turned off.Blocking these parts will cause the interior of the unit to
Operating the audio system for a long period of time withoverheat and will result in fire or other damage.
the engine turned off will drain the battery.QDo not install the product where it is exposed to
QDo not expose the unit to direct sunlight or exces-strong vibrations or is unstable.
sive heat.Avoid slanted or strongly curved surfaces for installation. If
Otherwise these will raise the interior temperature of thethe installation is not stable, the unit may fall down while
unit, and it may lead to smoke, fire, or other damage to thedriving and this can lead to an accident or injury.
unit.QInstallation Angle
QDo not use the product where it will be exposed toThe product should be installed in a horizontal position
water, moisture, or dust.with the front end up at a convenient angle, but not more
Exposure of the unit to water, moisture, or dust may leadthan 30u.
to smoke, fire, or other damage to the unit. Make especiallyThe user should bear in mind that in some areas there may
sure that the unit does not get wet in car washes or onbe restrictions on how and where this unit must be
rainy days.installed. Consult your dealer for further details.
QSet the volume level to low enough before the AUXQWear gloves for safety. Make sure that wiring is
connection is completed.completed before installation.
Failure to observe this, the loud noise may come out andQTo prevent damage to the unit, do not connect the
damage your speakers and your hearing. Direct connectionpower connector until the whole wiring is complet-
of the speaker/headphone output of an external deviceed.
without any attenuator may distort sound or damage theQDo not connect more than one speaker to one set
connected external device.
of speaker leads. (except for connecting to a
Observe the following cautions whentweeter)
installing.
QRefer wiring and installation to qualified service
personnel.
Installation of this unit requires special skills and experi-
ence. For maximum safety, have it installed by your dealer.
Panasonic is not liable for any problems resulting from
your own installation of the unit.
QFollow the instructions to install and wire the prod-
uct.
Not following the instructions to properly install and wire
the product could cause an accident or fire.
CAUTION:
Y PLEASE FOLLOW THE LAWS AND REGULATIONS OF YOUR STATE, PROVINCE OR COUNTRY FOR WIRING,
INSTALLATION, AND USE OF THIS UNIT AND THE DEVICES TO BE CONNECTED.
CQ-VX100U3 |
ACEC
PANASONIC
