Connecting Other ComponentsNContinued
Connecting a Component with a Digital Audio Output (CR-515 Asian model only)
The following diagram shows how to connect a component with an optical digital audio output, such as a CD recorder,
MD recorder, games console, satellite tuner, or personal computer.
Connect the CD receiverOs OPTICAL DIGITAL IN jack to an optical digital audio output on the other component.
You can change the Input Display for the OPTICAL DIGITAL IN to DIGITAL, CDR, PC, or GAME so that it matches
the type of component that you connect (see page 29).
Satellite tuner, CD
: Signal �owrecorder, etc.
DIGITAL
OUTPUT
CR-515 Asian modelOs
rear panel
Optical digital audio cable
Personal computer
Connecting an Onkyo Component with a Digital Audio Output
The following diagram shows how to connect an Onkyo component with an optical digital audio output.
Connect the CD receiverOs OPTICAL DIGITAL IN jack to an optical digital audio output on the Onkyo component.
Onkyo component with a
digital audio output
CR-515 Asian modelOs DIGITAL
INPUT OUTPUTOUTPUT
rear panel(REC)(PLAY)REMOTECONTROL
Analog audio cable (RCA)L
OUT
Red
MD/
TAPER
IN
White
OUTRed
DOCK/
CDR
IN cable
WhiteWhite RedRedWhite
RL
Optical digital audio cable
: Signal �ow
What can you do with ?
Y Connecting an Onkyo component to the CD receiver with an cable allows you to control the component with the
CD receiverOs remote controller. In addition, when playback is started on the component, the CD receiver will auto-
matically select it as the input source.
YTo use , you must connect the Onkyo component to the CD receiver with an cable and an analog audio cable
(RCA). In addition, you must change the Input Display for the DIGITAL IN so that it matches the type of component
that you connect. When you connect a CD recorder to the DOCK/CDR jacks and OPTICAL DIGITAL IN jack, you
must set the Input Display for DOCK/CDR to OCD-R,� and set the Input Display for OPTICAL DIGITAL IN to
OCD-R/dig� (see page 29).
Y If you connect an audio processor such as the Onkyo UE-205, you must set the Input Display for DOCK/CDR to
OPC,� and set the Input Display for OPTICAL DIGITAL IN to OPC/dig,� otherwise the wrong input source may be
selected when playback starts (see page 29).
Y Some -capable components have two jacks. TheyOre both the same, so you can use either one. The extra jack
is for connecting additional -capable components.
24 |
ACEC
ONKYO
