HELPFUL INFORMATIONENERGY SAVING AND OPERATION
HINTS
Auto Operation Button
Auto Restart Control
Y If power is resumed after a power failure, the Setting the Temperature
ECONOMYECONOMYECONOMYECONOMYPOPOPOPOWERFULWERFULWERFULWERFULPOPOPOPOWERWERWERWER QUQUQQUUIIIETIETEETTTIMERTIMERTIMERTIMERoperation will restart automatically after 3 - 4Y Approximately 10% of electricity can be saved.
minutes.Y Set the temperature higher or lower than the
Y Operation will be restarted automatically under thedesired temperature.
Y Raise the front panel and press.
previous operation mode and airflow direction when
power is resumed as the operation is not stoppedCooling Model
Automatic Operationby the remote control.
Y If the remote control fails to function or has beenCooling Operation : 2!F higher
misplaced, press the Auto Operation button to start Timer Setting
the Automatic operation.Y When power failure occurs, the timer setting will beHeat Pump Model
cancelled. Once power is resumed, reset the timer.
Y The Automatic operation will be activatedCooling Operation : 2!F higher
immediately once the Auto operation button is
Thunder and LightningHeating Operation : 4!F lower
pressed. However, temperature cannot be adjustedY This air conditioner is equipped with a built-in surge
when in this mode.protective device. However, in order to further
Y The power indicator on the indoor unit will blink untilprotect your air conditioner from being damaged by Air Filters
the operation mode is selected automatically.abnormally strong lightning activity, you may switchY Clean the air filters every 2 weeks.
Y To cancel this operation, press once more.off the circuit breaker.Y Dirty filters may reduces cooling or heating
efficiency.
Remote Control Signal Receiving Sound
Y To switch off the beep (Signal Receiving Sound), Keep All Doors and Windows Closed
Y Otherwise, cooling or heating performance will be
press the Auto Operation button for 10 secondsreduced and electricity cost is wasted.
continuously or longer.
A Obeep�, Obeep� sound will be heard at the Outdoor Unit
tenth seconds.Y Do not block the air outlet vents. Otherwise, it will
Note : A Obeep� sound will be heard at the fifthlower the cooling or heating performance.
seconds;
However please press continuously until you Timer
heard Obeep�, Obeep� sound.Y To prevent wastage of electricity, use Timer when
going out.
Y Repeat the above steps if you want to switch on the
Signal Receiving Sound.
Avoid Direct Sunlight
Y Keep curtains or drapes closed to avoid direct
(This is for Servicing purposes only.)
sunlight during cooling operation.
Note: If you press this button continuously for 5 to 10
seconds, Test Run operation will be performed. A
Obeep� sound will be heard after five seconds
indicating the Test Run starts to operate.
9 |
ACEC
PANASONIC
