Power supply
Using on batteries
OPE/BATTOpen the lid of the battery compartment on the rear and
insert eight R14 (size C) batteries, not supplied, as
illustrated below. Then close the lid.
To switch from AC power supply to battery supply,
disconnect the AC cord from the AC inlet.
The OPE/BATT indicator lights up while the power is
on.
R14 (C)
Using on AC house current
Connect the AC cord as illustrated below.When the OPE/BATT indicator becomes dim, volume
decreases, or sound is distorted during operation,
replace the batteries.
When the batteries become weak during tape
operation, OLo� flashes in the display. In stop mode, the
unit will not accept REC, e PLAY/PAUSE, f and
g. In playback or recording mode, the unit will be
stopped and turned off.
Replace the batteries.
1 to the AC inlet of the unitNotes on batteries
supplied AC cordTo avoid damage from leakage or explosion, observe
2 to an AC outletthe following:
(AC 120 V, 60 Hz) YInsert the batteries with the 0 and 9 marks correctly
aligned.
YDo not mix different types of batteries or old batteries
Y The rated voltage of the unit is 120 V AC.
YIf abnormal high voltage is supplied, OHi� flashes inwith new ones.
the display and the unit does not accept anyYWhen the unit is not to be used for a long period,
remove the batteries.
operation. Disconnect the AC cord.YNever recharge the batteries, apply heat to them or
CAUTIONtake them apart.
YRemove dead batteries.
Use only the supplied AC cord. Use with other cordsIf liquid leaks from the batteries, wipe thoroughly to
may result in the risk of fire.
remove.
Maintenance
To clean the cabinetAfter every 10 hours of use, clean the tape heads
Use a soft cloth lightly moistened with mild detergentwith a head cleaning cassette.
solution. Do not use strong solvents such as alcohol,Use separately sold dry-type or wet-type cleaning
benzine or thinner.cassette.
Refer to the instructions of the cleaning cassette for
To clean the headsdetails.
When the tape heads are dirty;
- high frequency sound is not emittedTo clean the lensLens
- the sound is not adequately highUse a cotton swab slightly
- the sound is off-balancemoistened with cleaning
- the tape cannot be erasedfluid. Wipe gently from the
- the tape cannot be recorded oncenter to the edge.
4 ENGLISH |
ACEC
AIWA
