3 Disassembly and Reassembly
3-1-8 Removing the Video PCB Assembly 3-1-10 Removing the Main PCB
Rear Shield and Video PCB1. Remove 7 screws on the main PCB.
1. Remove the 8 screws on the PCB Assembly.2. Pull the Main PCB towards you and carefully
2. Using pinch-nosed pliers or long-nosed pliers,lift out the main PCB and placet it on a flat,
pull both side taps of Video PCB Assembly.level surface that is protected from static
electricity.
3. Lift off the Video PCB Assembly Rear Shield.
4. Remove the 3 screws on the Video PCB
Bracket.3-1-11 Removing the Bracket
5. Lift out the Video PCB and pleat it on a flat,
level surface that is protected from static1. Remove the 10 screws on the Front Cabinet.
electricity.
3-1-12 Removing the Degaussing Coil
3-1-9 Removing the Main PCB Assembly
1. Using pinch-nosed pliers or long-nosed pliers,
1. Remove both side screws (4 screws) on thecarefully push the 4 plastic ties on the Bracket.
lower edge of the CRT Bracket.
2. Remove Chassis Ground Wire on the side of2. Lift the Degaussing Coil Assembly from the
Bracket.
the left.
3. Disconnect CN203, CN601, H_DY, CN205 and
Anode Cap on the Main PCB Assembly.
3-2 Reassembly
Reassembly procedures are in the reverse order of Disassembly procedures.
3-2CSE78**T/CSE98**T |
ACEC
SAMSUNG
