Electrical connections
Any electrical work required to installA cut off plug inserted into a 13 amp
this cooker should be carried out by asocket is a serious safety (shock) hazard.
qualified electrician or competent person, inEnsure that the cut off plug is disposed of
accordance with the current regulations.safety.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability
should these safety measures not be
observed.
This cooker is designed to be connected to a
230-240V AC 50Hz electrical supply.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the cooker rating plate.The rating plate is located
on the oven frame.
Before connecting check that:
The cooker is supplied with a 3 core flexible
supply cord incorporating a 13amp plug fitted. In" The plug used for connection is easily
the event of having to change the fuse, a 13ampaccessible when the appliance is installed.
ASTA approved (BS 1362) fuse must be used.
Should the plug need to be replaced for anyPermanent Connection
reason, the wires in the mains lead are coloured
in accordance with the following code:In the case of a permanent connection, it is
necessary that you install a double pole switch
Green and Yellow - Earthbetween the cooker and the electricity supply
Blue - Neutral(mains), with a minimum gap of 3mm, between
Brown - Livethe switch contacts and of a type suitable for the
- Connect the green and yellow (earth) wire torequired load in compliance with the current
electric regulations.
the terminal in the plug which is marked with
the letter 'E' or the earth symbol orThe switch must not break the yellow and green
coloured green and yellow.earth cable at any point.
- Connect the blue (neutral) wire to the
terminal in the plug which is marked with theEnsure that the cooker supply cord does
letter 'N' or coloured black.
- Connect the brown (live) wire to the terminalnot come into contact with surfaces with
temperatures higher than 50 deg. C .
in the plug which is marked with the letter 'L'
or coloured red.
NOTE: The earth wire should be about 2 cm
longer than the live and neutral wires.
Upon completion there must be no cut, or stray
strands of wire present and the cord clamp must
be secure over the outer sheath.
19 |