22222
EngTo install bagger components to tractor
4
1
4
1. Rear Door
2. Support Bracket
2
3. 3/8 Carriage Bolt
6
5
1. Discharge Chute4. 3/8 Lock Nut
2
3
2. 3/8 Nut5. 3/8 x 63,5mm Hex Bolt
3. Flat Washer36. 10,3mm (13/32") flat
washer1
Remove discharge chute from rear of tractor. Unhook
the two (2) straps and pull chute out and away fromplate as shown. Tighten securely.
tractor.
While holding the rear door open, install the two upper
Remove the two (2) 3/8 nuts and flat washers from thesupport brackets through the back plate and to the
chassis, using the 3/8 x 19mm carriage bolts and locknuts
supplied. Tighten securely.
Assemble both support brackets to the outside of the
baggger support tube using two each 3/8 x 63,5mm hex
bolts13/32" I.D. flat washers and 3/8 locknuts from parts
bag. Tighten securely.
3
2
2
1
1
1. 3/8 Lock nut
2. Flat Washer
1. Hook
3. Support Tube
2. Discharge Chute
3. Back plate slot
bolts at the tractor back plate.
3
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor back
plate. This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
23 |
ACEC
HUSQVARNA
