Crisper Humidity Control
REFRIGERATOR CARE
(on some models)
You can control the amount of humidity in the moisture-sealed
crisper. Adjust the control to any setting between LOW and HIGH.Cleaning
LOW (open) for best storage of fruits and vegetables with skins.
HIGH (closed) for best storage of fresh, leafy vegetables. WARNING
Ice Maker
Turning the Ice Maker On/Off
To turn the ice maker ON, simply lower the wire shutoff arm.
To manually turn the ice maker OFF, lift the wire shutoff arm to the Explosion Hazard
OFF (arm up) position and listen for the click.
Use nonflammable cleaner.
NOTE: Your ice maker has an automatic shutoff. As ice is made,
the ice cubes will fill the ice storage bin and the ice cubes will Failure to do so can result in death, explosion, or fire.
raise the wire shutoff arm to the OFF (arm up) position. Do not
force the wire shutoff arm up or down.
Both the refrigerator and freezer sections defrost automatically.
However, clean both sections about once a month to keep odors
from building up. Wipe up spills immediately.
IMPORTANT: Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To avoid odor
transfer and drying out of food, wrap or cover foods tightly.
To Clean Your Refrigerator:
NOTE: Do not use abrasive or harsh cleaners such as window
sprays, scouring cleansers, flammable fluids, cleaning waxes,
concentrated detergents, bleaches or cleansers containing
petroleum products on plastic parts, interior and door liners or
Ice Production Rategaskets. Do not use paper towels, scouring pads, or other harsh
cleaning tools.
Allow 24 hours to produce the first batch of ice. Discard the 1. Unplug refrigerator or disconnect power.
first three batches of ice produced.
2. Hand wash, rinse, and dry removable parts and interior
The ice maker should produce approximately 8 to 12 batches surfaces thoroughly. Use a clean sponge or soft cloth and a
of ice in a 24-hour period.mild detergent in warm water.
To increase ice production, lower the freezer and refrigerator 3. Wash painted metal exteriors with a clean sponge or soft cloth
temperature. See ?Using the Controls.? Wait 24 hours and a mild detergent in warm water. Dry thoroughly with a soft
between adjustments.cloth.
4. Plug in refrigerator or reconnect power.
For maximum ice production (on some models), push the
switch to ICE PLUS. The ice maker should produce 16 to
20 batches of ice in a 24-hour period in the Ice Plus mode.
Changing the Light Bulb
NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to
Rememberreplace the bulb with one of the same size, shape, and wattage.
The quality of your ice will be only as good as the quality of the 1. Unplug refrigerator or disconnect power.
water supplied to your ice maker. Avoid connecting the ice 2. Reach behind the control panel and unscrew the bulb.
maker to a softened water supply. Water softener chemicals 3. Replace the bulb with a 40-watt appliance bulb.
(such as salt) can damage parts of the ice maker and lead to
4. Plug in refrigerator or reconnect power.
poor quality ice. If a softened water supply cannot be avoided,
make sure the water softener is operating properly and is well
maintained.
Do not use anything sharp to break up the ice in the bin. This
can cause damage to the ice container and the dispenser
mechanism.
Do not store anything on top of or in the ice maker or ice bin.
9 |
ACEC
WHIRLPOOL
