FOR THE INSTALLER
Technical information
Dimensionsheight with panel895 mm
height without panel850 mm
width397 mm
depth600 mm
Power supply voltage / frequency220-230 V / 50 Hz
Total power absorbed2300 W (10 A)
Heater rating1950 W
2
Water pressureminimum5 N/cm2 (0,5 kg/cm)
2
maximum80 N/cm2 (8 kg/cm)
Maximum loadcotton5 kg
synthetics2,5 kg
wool1 kg
Spinning speed500 rpm
Electrical consumption (washing at 60°C)1,3 kWh
This appliance complies with the following EC Directive :
- 72/23/EEC of 19.02.1973 - Low-Voltage Directive
- 89/336/EEC of 03.05.1989 (including Amentment Directive 92/31/EEC) - EMV Directive.
Installation
Unpacking
The parts protecting the inner components of
the machine during transit are red. They must
all be removed before using your machine for
the first time. These parts and their securing
means should be kept in case the machine has
to be transported again.
Unpack the appliance. Tilt the appliance
backwards. Give to one of the back corners a
quarter turn. The appliance comes free naturallyFig. 1Fig. 2
out the polystyrene basis. Take away this basis
(fig. 1).
Open the lid of the appliance and remove the
polystyrene and gummi wedges which block
the drum. Close the lid (fig. 2).
On the back part and with a spanner, removeB
A
the two red loosened spacers (A) (fig. 3).
The holes which are now visible must be closedFig 3Fig 4
with the plugs (B) provided with the appliance
(fig. 4).
Please ensure that these parts have been
removed from the machine and keep them in
case of next transport (fig. 5).
If you want to keep the alignment of your
appliance with the adjacent cupboards, you
have the possibility to cut the crossbar holding
Fig 5Fig 6
the hoses located at the back of your washing
machine (fig. 6).
36 |
ACEC
ZANKER
