SERVICE AND ADJUSTMENTS
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 35)
" Raise hood.
" Unsnap headlight wire connector.
" Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
" To replace, reverse above procedure.
HOOD
WEAK OR DEADFULLY CHARGED
BATTERYBATTERY
FIG. 34
HEADLIGHT WIRE
TO REPLACE HEADLIGHT BULBCONNECTOR
" Raise hood.
" Pull bulb holder out of the hole in the backside of the
grill.
" Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
" Close hood.
FIG. 35
INTERLOCKS AND RELAYS
ENGINE
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.TO AD JUST THROTTLE CON TROL CABLE
" Check wiring. See electrical wiring diagram in the The throttle control has been preset at the factory and
Repair Parts section.ad just ment should not be necessary. If adjustment is
necessary, see engine manual.
TO REPLACE FUSE
TO AD JUST CARBURETOR
Replace with 20 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.The carburetor has been preset at the factory and ad just ment
should not be necessary. However, minor ad just ment may be
required to compensate for differences in fuel, temperature,
altitude or load. If the carburetor does need adjustment,
see engine manual.
26 |
ACEC
HUSQVARNA
