Read before use
CAUTIONS REGARDING HANDLING
LocationInstalling the CMX-5000 in an EIA rack
Install the player in a well-ventilated location where it will not beThe screw holes on the front panel o the CMX-5000 are
exposed to high temperatures or humidity.designed for use in attaching the unit to a 19-inch EIA rack.
Do not install the player in a location which is exposed to direct� Remove the four legs on the unit before installing the unit in
sunlight, or near stoves or radiators. Excessive heat canthe rack.
adversely affect the cabinet and internal components.� Use four 3/16-inch-diameter, 3/8-inch-length screws to attach
Installation of the player in a damp or dusty environment mayto rack. (Screws not included with CMX-5000 CD player.)
aiso result in a malfunction and can be hazardous. AvoidNote
installation near cookers etc., where the player may be exposed� Never place this CD player directly above a power amplifier,
to oily smoke, steam or heat.as the heat given off by the amplifier might result in damage
to the unit. Placing the CD player directly above a power
Installation guidelinesamplifier might also result in ham radio signals being picked
up or in other types of interference.
� Placing and using the compact disc player for long periods on� Always be sure to remove the CD player from its rack before
heat-generating sources such as amplifiers or nearshipping.
spotlights, etc. will affect product performance. Avoid placing� When moving the CD player while still installed in its rack,
exercise caution to avoid subjecting the player to shocks or
the player on heat-generating sources.vibration.
� Install this compact disc player as far as possible away from
tuners and TV sets. A compact disc player installed in close
proximity to such equipment may cause noise or degradationCleaning the player
of the picture.
� Noise may be noticeable when an indoor antenna is used. InTo clean the PLAYER wipe with a polishing or a soft, dry cloth.
such cases, make use of an outdoor antenna or turn offFor stubborn dirt, moisten a soft cloth with a weak solution of
power to the compact disc player.neutral detergent (diluted in five to six parts water), wring the
� When the unit is used in a loud-sound environment, e.g., nearcloth well, and wipe away the dirt. Use a dry cloth to wipe the
a speaker, sound skip may occur. Install the unit away fromsurface dry. Do not use volatile liquids such as benzene or
the speaker or reduce the listening volume.thinner which will damage to the unit.
� Place this unit on a level surface and a stable platform.
� Be sure the player, including its audio and power supplyCD lens cleaner
cords, does not touch vibrating materials. Any cause of
vibration other than the insulators may cause the disc to skip.The playerOs pickup lens should not become dirty in normal use.
Take special care when using the player while it is installed inIf for some reason, the lens becomes soiled and malfunctions,
a carrying case.
contact your nearest PIONEER authorized service center. Lens
cleaners for CD players are commercially available, but special
care should be exercised in their use as some may cause
damage to the lens.
Storing discs
� Discs are made of the same kinds of plastic used for
conventional analog audio records. Be careful not to allow
discs to warp. Always store discs in their cases vertically,
avoiding locations with high heat, humidity, or extremely low
temperatures. Avoid leaving discs in cars; the interior of a car
in direct sunlight can become extremely hot.
� Always read and abide by the precautionary notes listed on
disc labels.
Do not place on or againstCondensation
vibrating materials!
When this unit is brought into a warm room from previously cold
surroundings or when the room temperature rises sharply,
condensation may form inside the unit and impair its
performance. In such cases, allow the unit to stand for about an
hour or raise the room temperature gradually.
4<DRB1254> |
ACEC
PIONEER
