HELPFUL INFORMATIONENERGY SAVING AND OPERATION
HINTS
Auto Operation Button Auto Restart Control
Y If power is resumed after a power failure, the
Setting the Temperature
operation will restart automatically after 3 - 5 1/2
minutes.Y Approximately 10% of electricity can be saved.
Y Set the temperature 1C higher than the desired
Y Operation will be restarted automatically under thetemperature.
previous operation mode and airflow direction when
power is resumed as the operation is not stopped Air Filters and Air Purifying Filters
by the remote control.Y Clean the air filters every 2 weeks and the Air
Purifying Filters every 6 months.
Confirm the knife switch at ON Timer SettingY Dirty filters may reduces cooling efficiency.
Y When power failure occurs, the timer setting will be
cancelled. Once power is resumed, reset the timer. Keep All Doors and Windows ClosedECONOMYECONOMYECONOMYECONOMYPOPOPOPOWERFULWERFULWERFULWERFULPOPOPOPOWERWERWERWER SLEEPSLEEPSLEEPSLEEPTIMERTIMERTIMERTIMER
Y Otherwise, cooling performance will be reduced and
Thunder and Lightningelectricity cost is wasted.
Raise the front panel and press
Y This air conditioner is equipped with a built-in surge
protective device. However, in order to further Outdoor Unit
protect your air conditioner from being damaged byY Do not block the air outlet vents. Otherwise, it will
Automatic Operation
abnormally strong lightning activity, you may switchlower the cooling performance.
Y If the remote control fails to function or has beenoff the knife switch.
misplaced, press the Auto Operation button to start
Timer and Sleep Mode
the Automatic operation.
Y To prevent wastage of electricity, use sleep mode
Y The Automatic operation will be activated
immediately once the Auto operation button iswhen sleeping or Timer when going out.
pressed. However, temperature cannot be adjusted
Avoid Direct Sunlight
in this operation.
Y The power indicator on the indoor unit will blink untilY Keep curtains or drapes closed to avoid direct
sunlight during cooling operation.
the operation mode is selected automatically.
Y To cancel this operation, press once more.
Remote Control Signal Receiving Sound
Y To switch off the beep (Signal Receiving Sound),
press the Auto Operation button for 10 seconds
continuously or longer.
Beep, beep sound will be heard at the tenth
seconds.
Note: Beep sound will be heard at the fifth
seconds;
However please press continuously until you
heard beep, beep sound.
Y Repeat the above steps if you want to switch on the
Signal Receiving Sound.
(This is for Servicing purposes only)
Note: If you press this button continuously for 5 to 10
seconds, Test Run operation will be performed.
A beep sound will be heard at the fifth seconds
indicating the Test Run starts to operate.
9 |
ACEC
PANASONIC
