HELPFUL INFORMATIONENERGY SAVING AND OPERATION
HINTS
Auto Operation Button
Auto Restart Control
Y If power is resumed after a power failure, the Setting the Temperature
ECONOMYECONOMYECONOMYECONOMYPOPOPOPOWERFULWERFULWERFULWERFULPOPOPOPOWERWERWERWER SLEEPSLEEPSLEEPSLEEP TIMERTIMERTIMERTIMERoperation will restart automatically after 3 - 5 1/2Y Approximately 10% of electricity can be saved.
minutes.Y Set the temperature 2!F higher than the desired
Y Raise the front panel and press.Y Operation will be restarted automatically under thetemperature.
previous operation mode and airflow direction when
power is resumed as the operation is not stopped Air Filters and Air Purifying Filters
Automatic Operationby the remote control.Y Clean the air filters every 2 weeks and the Air
Y If the remote control fails to function or has beenPurifying Filters every 6 months.
misplaced, press the Auto Operation button to start Timer SettingY Dirty filters may reduces cooling efficiency.
the Automatic operation.Y When power failure occurs, the timer setting will be
Y The Automatic operation will be activatedcancelled. Once power is resumed, reset the timer. Keep All Doors and Windows Closed
immediately once the Auto operation button isY Otherwise, cooling performance will be reduced and
pressed. However, temperature cannot be adjusted Thunder and Lightningelectricity cost is wasted.
in this operation.Y This air conditioner is equipped with a built-in surge
Y The power indicator on the indoor unit will blink untilprotective device. However, in order to further Outdoor Unit
the operation mode is selected automatically.protect your air conditioner from being damaged byY Do not block the air outlet vents. Otherwise, it will
Y To cancel this operation, press once more.abnormally strong lightning activity, you may switchlower the cooling performance.
off the main power supply and unplug from power
Remote Control Signal Receiving Soundsocket. Timer and Sleep Mode
Y To switch off the beep (Signal Receiving Sound),Y To prevent wastage of electricity, use sleep mode
press the Auto Operation button for 10 secondswhen sleeping or Timer when going out.
continuously or longer.
OBeep�, Obeep� sound will be heard at the tenth Avoid Direct Sunlight
seconds.Y Keep curtains or drapes closed to avoid direct
Note: OBeep� sound will be heard at the fifthsunlight during cooling operation.
seconds;
However please press continuously until you
heard Obeep�, Obeep� sound.
Y Repeat the above steps if you want to switch on the
Signal Receiving Sound.
(This is for Servicing purposes only.)
Note: If you press this button continuously for 5 to 10
seconds, Test Run operation will be performed. A
Obeep� sound will be heard at the fifth seconds
indicating the Test Run starts to operate.
9 |
ACEC
PANASONIC
