CV OM 5/14/04 3:06 PM Page 9
SYSTEM CONNECTION
The CVSUB50 subwoofer full-range signal through theMake sure that you have
is equipped with only onesubwoofer output or withconfigured your surround
input � a dedicated low-components that only have sound processor for OSub-
frequency effects (LFE) input.a line-level (preamp) output,woofer On.� Also configure
Since the LFE channel is byunless an outboard low-passyour receiver for 5.1-, 6.1-
definition limited to only thecrossover is used to filter theor 7.1-channel operation, as
lowest portion of the fre-signal.appropriate. The front left,
quency spectrum, it is cru-front right, center and rear
Use the line-level input jack
cial that your receiverOs out-speakers should all be set
marked OLFE� for the low-
put be compatible. Theto OSmall.� If your receiver
frequency effects channel.
CVSUB50 should only beallows you to set the cross-
Connect this jack to the LFE
used with receivers or(subwoofer) output on yourover frequency between
processors that have digitalthe subwoofer and the main
receiver or processor.
surround decoders, such asspeakers, select 90Hz or the
Connect each speaker to
¨
Dolby* Digital or DTS.Dosetting that is the closest
the corresponding speaker
not use the CVSUB50 withterminals on your receiver frequency below it (80Hz if
components that output aavailable).
or amplifier.
Left FrontCenterRight Front
? +
? +? +
Subwoofer
LFE In
Receiver
LeftSubwoofer Right
Front(LFE) OutFront
? +? +
? +
Center
LeftSurround BackSurround BackRight
SurroundLeftRightSurround
? +? +? +? +
Surround BackSurround Back
Left SurroundRight Surround
LeftRight
? +? +? +? +
9 |
ACEC
JBL
