Remote controller
Precaution:The Remote Controller will not function properly if strong light strikes the sensor window of the air
conditioner or if there are obstacles between the Remote Controller and the air conditioner.
OPERATION BUTTON
Y To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
Y This button takes priority over any other buttons.
Y When you first turn it on, the air conditioner is on the High cool mode and the temp. at 72°F (22°C).
ROOM TEMPERATURE SETTING BUTTON
This button can automatically control the temperature of the room. The temperature
can be set within a range of 60°F to 86°F by 1°F. (16°C to 30°C by 1°C)
Select a lower number for a lower temperature in the room.
OPERATION
ON/OFF TIMER BUTTON
Y You can set the time when the unit will turn on or turn off automatically by pressing the timer TEMP
button. If the unit is in operation, this button controls the time it will be turned off. If the unit is
in off state, this button controls the time it will start. Every time you push this button, the
TIMERremaining time will be set as follows:
- STOPPING OPERATION
Y Every time you push this button, when the air conditioner is operating, timer is set as
MODEFAN SPEEDfollows : (1Hour 2Hours 3Hours 4Hours 5Hours 6Hours 7Hours
8Hours 9Hours 10Hours 11Hours 12Hours 0Hour 1Hour 2Hours ...)
Y The Setting Temperature will be raised by 2°F (1°C) 30 min. later and by 2°F (1°C) after
another 30 min.ECONOMY
- STARTING OPERATION
AbouttheControlsontheAirConditionerY Every time you push this button, when the air conditioner is not operating, timer is set as
follows : (1Hour 2Hours 3Hours 4Hours 5Hours 6Hours 7Hours
8Hours 9Hours 10Hours 11Hours 12Hours 0Hour 1Hour 2Hours ...)
OPERATION MODE SELECTION BUTTON
Y Every time you push this button, it will toggle between COOL, ECONOMY, FAN
and DRY.
ECONOMY
Y If you push this button, the fan stops when the compressor stops cooling. Approximately every
3 minutes the fan will turn on and check the room air to determine if cooling is needed.
FAN SPEED SELECTION BUTTON
Every time you push this button, it is set as follows.
{High(F2) Low(F1) High(F2)...}.
How to Insert Batteries
Y Do not use rechargeable batteries.
1.Remove the cover from the back of theSuch batteries
remote differ from standard dry cells in
controllershape, dimensions, and
performance.
2.Insert two batteries.
Y Be sure that the (+) and (-) directions areY Remove the batteries from the
correct.remote controller if the air
Y Be sure that both batteries are new.conditioner is not going to be used
3.Re-attach the cover.for an extended length of time.
Y Keep the remote control away from
infants and small children to
prevent them from accidentally
swallowing the batteries.
6 |
ACEC
PANASONIC
