ENGLISH
WARNINGPRECAUTIONS
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.Read the Operating Instructions carefully and completely before
operating the unit. Be sure to keep the Operating Instructions
for future reference. All warnings and cautions in the Operating
Instructions and on the unit should be strictly followed, as well
CAUTIONas the safety suggestions below.
RISK OF ELECTRIC SHOCK
DO NOT OPENInstallation
1 Water and moisture N Do not use this unit near water, such
as near a bathtub, washbowl, swimming pool, or the like.
OCAUTION:TO REDUCE THE RISK OF
2 Heat N Do not use this unit near sources of heat, including
ELECTRIC SHOCK,heating vents, stoves, or other appliances that generate heat.
DO NOT REMOVE COVER (OR BACK).
It also should not be placed in temperatures less than 5!C
NO USER-SERVICEABLE PARTS INSIDE.(41!F) or greater than 35!C (95!F).
REFER SERVICING TO QUALIFIED
3 Mounting surface N Place the unit on a flat, even surface.
SERVICE PERSONNEL.�4 Ventilation N The unit should be situated with adequate
space around it so that proper heat ventilation is assured.
Allow 10 cm (4 in.) clearance from the rear and the top of the
Explanation of Graphical Symbols:unit, and 5 cm (2 in.) from each side.
- Do not place the unit on a bed, rug, or similar surface that
The lightning flash with arrowhead symbol,may block the ventilation openings.
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated- Do not install the unit in a bookcase, cabinet, or airtight rack
Odangerous voltage� within the productOswhere ventilation may be impeded.
enclosure that may be of sufficient magnitude5 Objects and liquid entry N Take care that objects or liquids
to constitute a risk of electric shock to personsdo not get inside the unit through the v.entilation openings.
6 Carts and stands N When placed
The exclamation point within an equilateralor mounted on a stand or cart, the
triangle is intended to alert the user to the
presence of important operating andunit should be moved with care.
maintenance (servicing) instructions in theQuick stops, excessive force, and
literature accompanying the appliance.uneven surfaces may cause the
unit or cart to overturn or fall.
7 Condensation N Moisture may form on the CD pickup lens
when:
- The unit is moved from a cold spot to a warm spot
NOTE- The heating system has just been turned on
This equipment has been tested and found to comply with the- The unit is used in a very humid room
limits for a Class B digital device, pursuant to Part 15 of the FCC- The unit is cooled by an air conditioner
Rules. These limits are designed to provide reasonable protectionWhen this unit has condensation inside, it may not function
against harmful interference in a residential installation.normally. Should this occur, leave the unit for a few hours,
This equipment generates, uses, and can radiate radio frequencythen try to operate again.
energy and, if not installed and used in accordance with the8 Wall or ceiling mounting N The unit should not be mounted
instructions, may cause harmful interference to radioon a wall or ceiling, unless specified in the Operating
communications. However, there is no guarantee that interfInstrerenceuctions.
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, whichElectric Power
can be determined by turning the equipment off and on, the user1 Power sources N Connect this unit only to power sources
is encouraged to try to correct the interference by one or more ofspecified in the Operating Instructions, and as marked on the
the following measures:unit.
- Reorient or relocate the receiving antenna.2 Polarization N As a safety feature, some units are equipped
- Increase the separation between the equipment and receivwith polarer.ized AC power plugs which can only be inserted
- Connect the equipment into an outlet on circuit diffone werent fromay into a power outlet. If it is difficult or impossible to
that to which the receiver is connected.insert the AC power plug into an outlet, turn the plug over and
- Consult the dealer or an experienced radio/TV techniciantry again. If it still does not easily insert into the outlet, please
for help.call a qualified service technician to service or replace the
outlet. To avoid defeating the safety feature of the polarized
CAUTIONplug, do not force it into a power outlet.
Modifications or adjustments to this product, which are not3 AC power cord
expressly approved by the manufacturer, may void the userO- When disconnecting the AsC power cord, pull it out by the
right or authority to operate this product.AC power plug. Do not pull the cord itself.
- Never handle the AC power plug with wet hands, as this
could result in fire or shock.
- Power cords should be firmly secured to avoid being severely
bent, pinched, or walked upon. Pay particular attention to
the cord from the unit to the power outlet.
- Avoid overloading AC outlets and extension cords beyond
their capacity, as this could result in fire or shock.
2 ENGLISH |
ACEC
AIWA
