EE
NN
Installation
GG
LL
II
SS
HWARNING:WorkFlowH
7Haveaprofessionaltechnicianwireandinstalltheproduct.8
Note:There are Ţ ve main steps to install the main unit.
Professionalskillandexperienceisrequiredtowireandinstalltheproduct.Improperinstallationcould
e The Ţ gure below shows installation in a simpliŢ ed For each step, follow the detailed procedures on
resultinfailureofsafetyequipmentresultinginaccidentandinjury.
way. Do not rely on this Ţ gure alone as the basis page 22` 29.
Forsafetyssake,alwaysaskthestorefromwhichyoupurchasedtheproducttoinstallandwireitfor
for installation. Instead, be sure to follow the
you.
procedure on the following pages.
Removetheheadlinerfrom
1
Ceiling
Caution:
thevehicleforinstallation
reinforcement
e Wearglovesforinstallationworktoprotectyourselffrominjuries.Failuretoheedthiscautionmay
crosspieces(page22).
resultinanaccidentand/orinjury.Ceiling panel
e Weargogglesorprotectiveeyeweartoshieldyoureyesfromairbornemetalparticlesduringdrilling.
Failuretoheedthiscautionmayresultinanaccidentand/orinjury.
Attachtheupperandlower
2
slideplatesandbaseplate
Introduction
totheceilingreinforcement
A sample installation is shown below for your reference.crosspieces(page22,23).
First remove the headliner. Next, Ţ rmly attach the included upper and lower slide plates and base plate to the
two ceiling reinforcement crosspieces. Finally replace the headliner as it was and attach the main unit.
Wiretheunitandreplacethe
3
Wiring
headliner(page24,25).
Ceiling reinforcement
crosspiecesGetreadytoattachthemain
4
unit(page26,27).
Slide plate (upper),
slide plate (lower),
base plate
Connectthewiresandattach
5
themainunit(page28,29).
CY-VHD9401U/
CY-VHD9401L
CY-VHD9401U/
Front cover
CY-VHD9401L
2021
CY-VHD9401U/LCY-VHD9401U/L |
ACEC
PANASONIC
