Operating sequence
1. Check the filters9. At the end of the washing
Ensure that they are clean and properly positioned. programme
(See "Maintenance and cleaning" - Instruction
book - Part 1)At the end of the programme the dishwasher will
automatically stop.
The On/Off indicator light remains on until the On/Off
push button is depressed.
2. Check that there is rinse aid and
salt
(See Instruction book - Part 1)10. Switch off the dishwasher
Switch off the dishwasher by pressing the On/Off
push button.
Wait 15/20 minutes before opening the
3. Load the dishes
dishwashers door; in this way you will avoid
Remove any scraps of food. burning yourself when removing the dishes and
Pull the lower basket out and arrange the avoid also the damage of the nearby furniture
saucepans, plates and cutlery in it. caused by the escape of steam.
Pull the upper basket out and arrange the plates, Empty the lower basket first and then the upper one;
saucers, glasses and cups etc. in it. this will avoid water dripping from the upper basket
onto the dishes in the lower one.
Slide the baskets back into the machine.
When the washing programme has finished, it
4. Ensure that the spray arms can
is recommended that the dishwasher is
rotate freely unplugged and the water tap turned off.
In general it is not advisable to open the door
while the machine is working; if the door is
5. Measure out detergent opened however, a safety device ensures that
the machine stops.
Add the detergent into the dispenser according to
the dosage quantity given in the "Washing
programmes" chart.
Close the detergent dispenser lid.
Important!
Care must be taken if the door is opened during
the hot phase or immediately after a
6. Close the dishwasher door
programme has finished, as steam may escape.
7. Set the programme
Turn the programme selector dial clockwise until
the letter of the programme you wish to select
corresponds with the programme marker on the
control panel.
If necessary select the temperature of the main
wash according to the instructions in the Washing
programmes chart (see Required push buttons).
8. Start the programme
Depress the On/Off push button.
The On/Off indicator light will come on and the
machine will start.
If you wish to interrupt the washing programme at
any time press this button again.
11 |
ACEC
ZANUSSI
